32 GB ADATA DIMM 5600 (2x 16 GB) Dual-Kit (preto, AX5U5600C4616G-DTLABBK, XPG Lancer Blade, INTEL XMP, AMD EXPO)

The ADATA Lancer Blade DDR5 32 GB 5600 MHz memory module is a dual-channel kit consisting of two 16 GB DDR5 modules. It offers a 5600 MHz data rate, CAS latency 45 and on-die ECC for improved stability. The module features a compact low-profile heatsink that fits smaller PC cases and reduces interference with tall CPU coolers. Built-in Power Management IC (PMIC) and support for AMD EXPO and Intel XMP 3.0 provide stable power delivery and simplified memory overclocking.

Advantages

The low-profile heatsink design allows installation in compact systems without obstructing CPU coolers. On-die ECC increases run-time reliability by correcting memory errors internally. Integrated PMIC improves power stability and efficiency, while support for AMD EXPO and Intel XMP 3.0 enables easier platform tuning and overclocking. High-quality ICs and PCBs support consistent performance and headroom for moderate overclocking.

Suitable for

• Gaming PCs requiring 32 GB DDR5 memory for modern titles
• Content creation and multitasking workstations
• Small-form-factor (SFF) builds where low-profile modules are needed
• Systems where improved stability and ECC correction are desired

Key specifications

• Capacity: 32 GB (2 × 16 GB)
• Memory type: DDR5
• Speed: 5600 MHz
• CAS latency: CL45
• On-die ECC: yes
• Memory voltage: 1.4 V (boost) and 1.1 V (default)
• Form factor: low-profile module with heatsink
• Compatibility: supports AMD EXPO and Intel XMP 3.0

How to use

Install the two modules into matching DIMM slots following your motherboard manual to enable dual-channel operation. Ensure the system is powered off and ground yourself before handling modules. After installation, enter the BIOS/UEFI to confirm detection of 32 GB and 5600 MHz; enable AMD EXPO or Intel XMP 3.0 profiles if you wish to apply rated timings and frequency automatically. If your platform does not support the advertised profile, set safe defaults and consult the motherboard documentation for manual tuning.

Recommendations

For best results, use the ADATA Lancer Blade DDR5 in a motherboard that explicitly supports DDR5 5600 MHz or higher and follow the motherboard vendor’s guidance when enabling EXPO or XMP profiles. Keep airflow over the module adequate in compact cases to maintain thermal stability during sustained loads.