Adaptador Multi-Link Barrow 90° para tubo rígido de 14 mm TWT90KNS-K14 preto

The Barrow Multi-Link Adapter 90° for 14mm Hard Tube TWT90KNS-K14 Black is a right-angle connector engineered for custom PC liquid cooling loops using 14 mm hard tubing. Finished in matte black, this adapter delivers a compact 90-degree turn that helps route rigid tubes cleanly and maintain a tidy layout in confined spaces. It reduces tube bending and alignment issues by providing a stable, fixed-angle connection between two lengths of hard pipe.

Advantages

This 90° adapter simplifies tube routing by providing a precise, repeatable angle for 14 mm hard tubing, improving layout symmetry and reducing mechanical stress on adjacent fittings. The black finish minimizes visual distraction inside the case and matches common black components. The compact design helps free up space near reservoirs, radiators, and motherboards, enabling cleaner installations in tight or crowded enclosures.

Suitable for

• Custom PC water cooling loops with 14 mm hard tubing
• Tight or compact PC cases where space-efficient routing is required
• Builds that demand precise tube direction changes without heat-softening or bending

Key specifications

• Angle: 90° fixed elbow
• Tube compatibility: designed for 14 mm hard rigid tubing
• Finish: black coating suitable for visible interior use
• Form factor: compact inline adapter for minimal footprint
• Material characteristics: engineered for installation with hard tubing and compression fittings

How to use

Install the adapter as part of a sealed liquid cooling loop by inserting 14 mm hard tube ends into the adapter’s connection points and securing them with compatible compression fittings. Ensure tube ends are cut square and deburred before installation for a reliable seal. Orient the adapter to achieve the desired 90° turn, then tighten fittings to manufacturer torque recommendations for compression-style hardware. Verify alignment and clearances relative to nearby components before fully tightening.

Recommendations

Use with correctly sized 14 mm hard tubing and compatible compression fittings. Always check for leaks after initial fill and pressure test the loop at low pressure if possible. Avoid forcing tube bends; use the adapter to redirect rigid tubing where needed and ensure all sealing surfaces are clean and undamaged prior to assembly.