Cabo de alimentação ACT ficha CEE 7/7 (angular) - C19 preto 1,2 m

The ACT Powercord CEE 7/7 male angled to C19 black 1.2 m is a mains power cable designed to deliver up to 230 V and 16 A to equipment that accepts an IEC C19 inlet. The cable features an angled CEE 7/7 plug for a low-profile connection at the wall socket and a straight C19 coupler for connection to servers, PDUs, UPS units and other high-current devices. The 1.2 m length and black jacket provide a practical balance between reach and tidy cable management in rack, cabinet or desktop installations.

Advantages

The angled CEE 7/7 male connector reduces strain at the wall outlet and allows the cable to run closer to surfaces, improving space efficiency. The C19 coupler supports higher-current power delivery compared with smaller IEC connectors, making the cable suitable for many server and network components. The 1.2 m length keeps excess cable to a minimum while providing sufficient reach for most typical mounting scenarios.

Suitable for

• Connecting servers, rack power distribution units (PDUs) and UPS systems with IEC C19 inlets
• Office and home equipment that requires a C19 connection and 16 A power
• Installations where an angled wall plug improves cable routing and reduces bend stress
• Short to medium cable runs in cabinets, racks or workstations

When it may not be suitable

This cable is not suitable for equipment requiring connectors other than C19 or for outlets that do not accept the CEE 7/7 plug. It should not be used where a longer reach is necessary than 1.2 m, or where a different current or voltage rating is specified by the device manufacturer.

Key specifications

• Cable length: 1.2 m
• Connector A: C19 coupler (IEC C19)
• Connector B: Angled CEE 7/7 male plug
• Rated voltage: 230 V
• Rated current: 16 A
• Colour: Black

How to use

Inspect the cable and connectors for damage before use. Insert the angled CEE 7/7 plug into a compatible mains outlet, taking care to align the plug correctly to avoid strain. Connect the C19 coupler to the device's IEC C19 inlet until it is fully seated. Route the cable to avoid sharp bends and pinch points and secure it as needed to maintain tidy cable management. Disconnect by powering down connected equipment if required and gently withdrawing each connector.

What to consider before purchase

• Verify that your device accepts an IEC C19 inlet.
• Confirm that a CEE 7/7 mains plug is compatible with your wall outlets.
• Ensure 1.2 m length is sufficient for your installation; consider longer cables for distant equipment.
• Check that 230 V / 16 A ratings meet the power requirements of your equipment.

Recommendations

Use the angled plug where space is limited near the socket and avoid using the cable in environments with excessive heat, moisture or mechanical stress. For permanent or critical installations, periodically inspect the cable and connectors for wear and replace if any damage is found.