Cabo de rede ACT Laranja 1 metro LSZH SFTP CAT6A sem patilhas com fichas RJ45

The ACT Orange 1 meter LSZH SFTP CAT6A patch cable with snagless RJ45 connectors is a 1 m network cable designed for high-speed data transmission and reduced signal interference. It features full copper AWG#26 conductors, S/FTP shielding and 50µ gold-plated RJ-45 contacts, and is suitable for installations that require Cat6A performance in a compact length.

Advantages

The cable uses full copper AWG#26 wires for consistent signal quality and 50µ gold-plated RJ-45 contacts for improved conductivity and corrosion resistance. S/FTP shielding reduces electromagnetic interference and crosstalk. The LSZH jacket lowers smoke and toxic emission in case of fire, and the snagless design protects the connector latch during installation. ACT specifications are independently verified and each cable is 100% tested to ensure conformity.

Suitable for

• Patch panels and switch-to-device connections in data centers and offices
• High-speed Ethernet links up to Cat6A performance
• Environments requiring low-smoke zero-halogen cabling
• Short-run connections where a 1 m cable is sufficient

Key specifications

• Length: 1 m
• Standard: Cat6A
• Shielding: S/FTP (shielded foil around pairs with overall braid)
• Conductor: full copper AWG#26
• Contacts: 50µ gold-plated RJ-45
• Connector type: RJ-45 to RJ-45, snagless
• Jacket: LSZH (Low Smoke Zero Halogen)
• Brand / MPN / EAN: ACT / FB7101 / 8716065314052

How to use

Connect one RJ-45 end to your network switch, patch panel or router and the other end to the target device (PC, server, access point). Ensure connectors are fully inserted until the latch clicks. Route the cable avoiding sharp bends and sources of strong electromagnetic interference for optimal performance.

Recommendations

For best results keep cable runs within recommended Ethernet lengths for Cat6A where applicable, avoid kinking the cable, and use in installations that benefit from LSZH properties. Verify compatibility with your equipment and test connections after installation.