Interruptores mecânicos para teclado GLORIOUS Glorious Panda Tactile – 36 unid., policarbonato, amarelo translúcido

Set of 36 GLORIOUS Glorious Panda Tactile mechanical keyboard switches with polycarbonate housings in translucent yellow. Built on the original INVYR Panda tooling, these tactile switches deliver a pronounced, rounded bump at the start of the downstroke and a smooth post-bump travel that finishes with a distinct "thock" sound. The switches are pre-lubed for smoother operation out of the box and use a 3-pin MX-style design for broad compatibility with hot-swap mechanical keyboards, including Glorious GMMK boards.

Advantages

Glorious Panda Tactile switches combine a recognized tactile profile with refined acoustics and consistent build tolerances. The pre-lubed internal components reduce scratchiness and friction while preserving the tactile bump, providing a buttery feel and a rich typing sound without excessive noise. Their translucent polycarbonate housings allow RGB lighting to pass through for backlit keyboards, and the MX-compatible stem accepts a wide range of keycap sets.

Suitable for

• Mechanical keyboard customization and switch upgrades
• Daily typing where tactile feedback is preferred
• Gaming that benefits from clear actuation points
• Backlit keyboards requiring good light transmission

Key specifications

• Switch type: Tactile (INVYR Panda tooling)
• Housing material: Polycarbonate (translucent yellow)
• Stem style: MX-compatible cross (+)
• Pin configuration: 3-pin MX-style for hot-swap compatibility
• Pre-lubed: Yes (thin factory-applied lubrication)
• Spring: 67 g internal spring (medium resistance)
• Actuation distance: 2.52 mm (typical)
• Actuation force: 49 gf (typical)
• Bottom-out distance: 3.25 mm (typical)
• Bottom-out force: 60 gf (typical)
• Quantity: 36 switches per pack

How to use

Install the switches into a compatible hot-swap mechanical keyboard by aligning the MX-style stem and the three mounting pins with the socket and pressing firmly until the switch seats. For solderable PCBs, desolder the existing switches and solder the Panda switches in place following standard soldering safety procedures. Pair with compatible keycaps by pressing the keycap onto the cross-shaped stem until secure. No additional break-in is required, though optional further lubrication or filming can be performed by experienced users to fine-tune feel and sound.

Recommendations

Use these switches in hot-swap keyboards for easy installation and replacement. For the best acoustic results, mount the switches in a board with a solid plate and consider pairing with compatible PBT or ABS keycaps. Avoid excessive lubrication if you want to retain the pronounced tactile bump. When soldering, follow proper ESD precautions and ventilation practices.