Módulo de memória CoreParts DDR2 8 GB 667 MHz ECC 2x4 GB

The CoreParts Memory Module DDR2 8GB 667MHz ECC (2x4GB) delivers 8 GB of DDR2 RAM in a dual-module kit designed for systems that support ECC memory. With a clock speed of 667 MHz and error-correcting code (ECC) capability, this memory kit aims to improve system stability and maintain data integrity. The modules come in a green PCB finish and are supplied as two 4 GB sticks for use in compatible motherboards and servers.

Advantages

This CoreParts DDR2 kit provides ECC support for automatic detection and correction of single-bit memory errors, helping to reduce data corruption and system crashes. The dual-module configuration (2x4 GB) enables straightforward capacity upgrades while matching typical DDR2 667 MHz timing and performance. The modules use standard form factor and original chipsets to ensure compatibility with certified systems that require ECC memory.

Suitable for

• Legacy servers and workstations that require DDR2 ECC memory
• Systems needing a stable 8 GB configuration using two 4 GB modules
• Repair or upgrade projects where matched DDR2 667 MHz modules are required

Key specifications

• Capacity: 8 GB (2x 4 GB)
• Memory type: DDR2
• Clock speed: 667 MHz
• ECC: Yes (error-correcting code)
• Colour: Green (PCB)
• MPN: MMA8221/8GB
• EAN: 5711045237164

How to use

Power off the computer and disconnect it from mains before installing the memory modules. Open the system chassis according to the manufacturer’s instructions, locate the compatible DDR2 ECC DIMM slots on the motherboard, and insert each 4 GB module firmly until the retention clips engage. Reassemble the chassis, reconnect power, and boot the system. Verify that the BIOS/UEFI recognizes the full 8 GB and that ECC functionality is enabled if required by the platform.

Recommendations

Install this 2x4 GB DDR2 667 MHz ECC kit in systems explicitly supporting ECC DDR2 memory. When mixing modules, use identical specifications to ensure stability. For mission-critical systems, enable ECC in firmware and run memory diagnostics after installation.