ACT Azul 90 metros S/FTP CAT6A B2ca PoE++ 100W cabo de instalação sólido pré-montado, ficha RJ45 – conector fêmea

The ACT S/FTP CAT6A B2ca PoE++ 100W prefab installation cable (FB0190) is a 90 m pre-terminated solid installation cable engineered for 10 Gigabit Ethernet and high-power PoE deployments. Constructed as S/FTP with full copper 23AWG conductors and screened foil shielding, the cable reduces electromagnetic interference and maintains signal integrity across long runs. Factory-fitted RJ45 male-to-female connectors use IDC termination and 50 µin gold-plated contacts to provide a durable, low-loss connection without field termination.

Advantages

The pre-terminated design removes the need for on-site assembly or special tools, enabling consistent, repeatable connections and reducing installation time and human error. Compliance with ANSI/TIA-568.2-D and ISO/IEC 11801-1 standards and CPR Euroclass B2ca rating ensures suitability for demanding installations. Support for 4PPoE / PoE++ up to 100 W allows powering of modern high-consumption devices over the same cable used for data.

Suitable for

When it may not be suitable

This solid pre-terminated cable is designed for fixed installations and may not be the best choice where frequent reconfiguration, extreme flexing, or continuous movement is expected; stranded patch cords are better suited to such conditions. It is also intended for in-wall or structured cabling runs rather than direct exposure to outdoor environmental conditions unless additional protection is applied.

Key specifications

How to use

Plan the cable route and measure run lengths to ensure the 90 m reach suits the installation. Route the prefab cable through conduits or cable trays as required and secure with appropriate cable management. Plug the pre-terminated RJ45 male end into the network device or patch panel and connect the RJ45 female end to the existing in-wall outlet or extension patch cord as needed. No termination tools are required; verify continuity and Ethernet link speed after installation and ensure cable bends do not exceed recommended bend radii.

What to consider before purchase

Recommendations

Use the pre-terminated ACT S/FTP CAT6A cable for permanent structured cabling runs in ceilings, walls, and cable trays where high bandwidth, interference protection, and up to 100 W PoE power are required. Avoid tight bends, protect against physical damage, and pair with compliant patch panels and equipment to maintain performance and safety.