ACT laranja 10 m cabo de patch U/UTP CAT6A com fichas RJ45

The ACT Orange 10 meter U/UTP CAT6A patch cable with RJ45 connectors is a high-performance copper Ethernet cable designed for reliable network connections. It features full copper conductors and gold-plated RJ45 contacts to ensure good conductivity and compatibility with PoE (Power over Ethernet) devices. The cable is U/UTP CAT6A rated, supports Gigabit Ethernet speeds, and its orange colour helps with easy identification in structured cabling setups.

Advantages

The cable uses full copper conductors that meet ANSI/TIA568-C2-1 performance requirements and CPR Euroclass Eca compliance, providing stable signal transmission and long-term reliability. Gold-plated RJ45 connectors reduce contact resistance for consistent connectivity. U/UTP construction minimizes external interference, making it suitable for high-speed data environments and PoE applications.

Suitable for

• Structured copper data networks
• Gigabit Ethernet (10/100/1000Base-T(X)) connections
• PoE and PoE+ devices
• Patch panels, switches and routers in office or data center racks

Key specifications

• Length: 10 m
• Cable category: CAT6A U/UTP
• Conductors: full copper
• Connectors: RJ-45 to RJ-45, gold-plated contacts
• Supported cabling technology: 10/100/1000Base-T(X)
• Colour: Orange
• Compliance: ANSI/TIA568-C2-1; CPR Euroclass Eca

How to use

Connect one RJ45 end to a network device such as a switch, router or patch panel and the other end to the target device (computer, access point, IP camera, etc.). Ensure connectors are fully seated until the latch clicks. Route the cable to avoid sharp bends and keep it separated from strong electrical interference sources. For permanent installations, secure the cable with suitable clips or cable management accessories to prevent strain on the connectors.

Recommendations

Use ACT patch cables with full copper conductors for PoE-powered equipment to ensure reliable power delivery. Avoid excessive bending and pulling; observe the manufacturer’s recommended bend radius and maximum pulling force during installation.