AOC CBO BlueOptics QSFP28 BO282803L10M Cabo ótico ativo 100G, 10 m

The AOC BlueOptics QSFP28 BO282803L10M 100G active optical cable by BlueOptics is a 10 meter duplex fiber link engineered for high-speed interconnects between switches, servers and other network devices with QSFP28 ports. The cable delivers 100 gigabit-per-second data transmission while reducing electrical interference and lowering power consumption compared with equivalent copper assemblies. Its active optical design provides reliable signal integrity over longer distances within data centers and enterprise network racks, and supports plug-and-play operation for straightforward deployment.

Advantages

This active optical cable provides a lightweight, low-latency connection that minimizes electromagnetic interference and thermal dissipation. The QSFP28 form factor ensures compatibility with standard 100G QSFP28 ports, and the optical medium enables consistent performance across the full 10 m reach. The cable’s construction reduces weight and cabling bulk in dense rack environments, and its plug-and-play nature simplifies installation without additional transceivers or configuration.

Suitable for

• 100G interconnects between top-of-rack and aggregation switches
• High-performance server-to-switch links in data centers
• Short-reach optical fabrics within enterprise network racks
• Environments requiring reduced electrical interference and lower heat dissipation

Key specifications

• Data rate: 100 Gbit/s over a duplex optical link
• Length: 10 meters
• Connector type: QSFP28 to QSFP28
• Medium: active optical cable (fiber)
• Form factor: QSFP28 compatible
• Typical use: short-reach data center and enterprise interconnects

How to use

Install the AOC by inserting each QSFP28 connector into the corresponding QSFP28 port on your network devices until the connector latches. Ensure both ends are matched to the intended ports and that host devices support 100G QSFP28 active optical connections. No additional transceivers or special configuration is required for basic link establishment; operating systems or switch firmware may report link status and diagnostics once the physical connection is in place. Handle the cable by the connector housings and avoid sharp bends in the fiber bundle to preserve signal quality.

Recommendations

For optimal performance, route the cable to avoid tight bends and mechanical strain, maintain clear airflow in racks to benefit from reduced heat dissipation, and verify device compatibility with QSFP28 AOCs. Use standard ESD precautions when handling connectors and inspect connector endfaces or protective caps before insertion to prevent contamination.