Aparafusadora para pladur EINHELL TP-DY 18 Li BL Solo 18 V, sem escovas, bateria não incluída (modelo 4261010)

The Einhell TP-DY 18 Li BL Solo is an 18 V cordless drywall screwdriver engineered for fastening plasterboard, gypsum boards and similar panel materials. As a Solo unit, it is supplied without battery or charger and fits Einhell 18 V battery systems. The brushless motor provides consistent torque delivery and reduced maintenance compared with brushed designs. The tool is intended for both professional installers and DIY users who need mobility, repeatable screw depth and reliable performance while mounting drywall, ceilings and partition systems.

Advantages

The brushless motor improves efficiency, delivers steady torque and extends tool life. Cordless operation gives full mobility on sites without constant access to mains power, while compatibility with the manufacturer’s 18 V battery platform allows shared use of batteries across tools. The screwdriver is designed for repetitive fastening with a mechanism for consistent screw seating depth, which reduces rework and speeds up installation. Its compact form factor supports access in confined spaces and overhead work.

Suitable for

• Installing plasterboard and gypsum board panels
• Securing ceiling panels and suspended ceilings
• Building non-load-bearing partition walls
• Drywall renovation, repair and interior finishing

Key specifications

• Rated voltage: 18 V (cordless battery-powered)
• Motor type: brushless (BL) for higher efficiency and durability
• Drive: screwdriver configuration optimized for drywall screws
• Form factor: compact, pistol-style housing for overhead and confined-space work
• Ergonomics: designed for extended hand-held operation with balance for repetitive use

How to use

Install a compatible 18 V battery and select the correct screw bit for the drywall screws you intend to use. Set the seating depth or torque setting according to panel thickness and screw type, then place the screw on the bit and drive it into the panel until the desired flush or slightly recessed finish is reached. For overhead work, support the panel edges and work in a consistent pattern to avoid panel distortion. Observe safe handling practices and secure workpieces before driving screws.

Recommendations

Use batteries with adequate remaining capacity for uninterrupted work; select a battery from the same 18 V platform to ensure compatibility. Choose the correct bit size and set the seating depth to avoid overdriving which can damage board surfaces. For long runs, rotate short breaks to avoid user fatigue and allow the tool to cool if performing continuous heavy fastening. Store the tool without batteries installed when not in use to avoid deep discharge.