Bico Flashforge C3P endurecido 0,8 mm – bico de aço endurecido 0,8 mm para Flashforge C3P

Hardened 0.8 mm nozzle designed for the Flashforge C3P 3D printer. Manufactured from wear-resistant hardened steel, this nozzle is intended for printing abrasive filaments and for applications that require higher extrusion flow. The 0.8 mm diameter provides a larger melt channel than standard nozzles, enabling increased material throughput, thicker layer heights and faster production of larger parts or prototypes. It is compatible as a direct replacement for the printer's standard nozzle to restore or change print width and speed.

Advantages

The hardened steel construction offers improved resistance to abrasion when using composite or filled filaments such as carbon-, metal- or glass-filled materials. A 0.8 mm orifice reduces the risk of clogging with coarser or particle-filled filaments and supports higher extrusion rates for faster printing of large models. Using a hardened nozzle can extend service life compared with softer metals when printing abrasive materials, and it allows stable extrusion at greater layer heights for prototyping and functional parts.

Suitable for

• Printing abrasive or filled filaments (carbon, metal, glass-filled)
• Large-format parts and rapid prototyping with thicker layers
• Applications requiring higher material throughput and faster print cycles
• Direct replacement to restore nozzle performance or adjust extrusion width

Key specifications

• Nozzle material: hardened steel for improved wear resistance
• Nozzle diameter: 0.8 mm orifice for higher flow
• Compatible printer model: designed for Flashforge C3P nozzle mount
• Suitable extrusion profile: supports thicker layer heights and increased filament flow

How to use

Allow the printer hot end to reach target temperature for the filament in use before removing the existing nozzle. Use appropriate tools to unscrew the current nozzle, taking care to avoid damage to the heater block and thermistor. Screw in the hardened 0.8 mm nozzle by hand until seated, then tighten carefully with a suitable wrench while the hot end is warm if recommended by the printer manufacturer. Calibrate extrusion multiplier, flow and layer height in slicer settings to account for the larger 0.8 mm nozzle diameter, and perform a test print to confirm bed leveling and extrusion consistency.

Recommendations

Adjust print settings when switching to the 0.8 mm hardened nozzle: increase layer height, line width and flow rate as appropriate, and lower print resolution expectations compared with finer nozzles. Maintain regular nozzle checks and cleanings when printing abrasive filaments; use proper tightening procedures to avoid damaging the hot end.