Cabo DAC QSFP28 BlueOptics SFP-DAC100-3M-BL, 3 m, QSFP28 para QSFP28, 100GBASE-CR4, preto

BlueOptics SFP-DAC100-3M-BL is a 3 m passive Direct Attach Cable (DAC) with QSFP28 connectors on both ends, designed for short-distance 100GBase-CR4 electrical links in data centers and rack-to-rack connections. The cable is a twinax copper solution intended for use where hardware platforms support passive QSFP28 twinax DACs.

Advantages

This passive QSFP28 DAC offers a simple, low-power connection for short-range 100 Gbit/s links. Its twinax copper design provides low latency and a compact, easy-to-install form factor. The cable is black, weighs approximately 0.15 kg and is compatible with equipment that accepts QSFP28 passive DACs.

Suitable for

• Short-distance connections between switches in a rack
• Inter-rack links in adjacent racks
• High-density switch-to-switch or switch-to-storage connections

When it may not be suitable

This passive DAC is intended for short-reach electrical links; it is not suitable for long-distance transmission or fiber-optic runs. It requires networking hardware that explicitly supports passive QSFP28 twinax DACs—using it in unsupported ports may result in incompatibility or loss of link functionality.

Key specifications

• Type: Passive Direct Attach Cable (DAC), twinax copper
• Connectors: QSFP28 male to QSFP28 male
• Data rate: up to 100 Gbit/s (100GBase-CR4)
• Length: 3 m
• Colour: Black
• Typical power draw: ~0.1 W (passive cable; actual consumption depends on connected devices)
• Approximate weight: 0.15 kg

How to use

Insert each QSFP28 connector into the QSFP28 port of the devices to be connected, ensuring the connectors are fully seated and any retention latches are engaged. Verify that both devices support passive QSFP28 DACs and the 100GBase-CR4 electrical interface. After physical installation, confirm link status and configure port settings on the switches or routers as required by your network design.

What to consider before purchase

• Confirm that your switches, routers or storage devices support passive QSFP28 twinax DACs and 100GBase-CR4.
• Ensure 3 m length is appropriate for your rack or inter-rack cabling plan.
• Check that electrical short-reach copper cabling is acceptable for your environment (versus optical solutions).

Recommendations

Use this BlueOptics QSFP28 DAC for short, high-bandwidth links in data center racks where low latency and low power consumption are priorities; avoid excessive bending of the twinax cable and keep within the recommended bend radius to maintain signal integrity.