AOC CBO SFP-AOC-10G-15M Cabo ótico ativo SFP+ de 15 m para 10GbE

The AOC CBO SFP-AOC-10G-15M is a 15-meter Active Optical Cable (AOC) with SFP+ connectors designed for 10 Gigabit Ethernet links. This factory-terminated cable creates a direct, low-latency optical connection between SFP+ ports on switches, servers or storage appliances without the need for separate transceivers. The optical design reduces power consumption and heat compared to equivalent copper direct-attach cables and supports high-density cabling requirements in racks and patch panels.

Advantages

The cable offers a plug-and-play solution with pre-terminated SFP+ modules, enabling quick installation and predictable signal performance. Its optical medium delivers lower power use and reduced thermal load relative to copper alternatives, helping to optimise data centre efficiency. The 15 m length provides flexibility for uplinks and server-to-switch links across typical rack and row layouts while preserving full 10GbE throughput and low latency.

Suitable for

• Data centre uplinks between switches and aggregation devices
• Server-to-switch and storage-to-switch connections in rack environments
• High-speed aggregation links and short-distance campus backbone segments
• Environments where reduced power and heat are required compared to copper cabling

Key specifications

• Interface: SFP+ to SFP+
• Rated data rate: 10 Gigabit Ethernet (10GbE)
• Length: 15 metres
• Cable type: Active Optical Cable (AOC)
• Latency: low, suitable for latency-sensitive applications
• Power consumption: lower than equivalent copper direct-attach assemblies
• Connector form factor: hot-pluggable SFP+ modules

How to use

Insert each SFP+ module into the corresponding SFP+ port on your switch, server or storage device until it latches. Ensure ports are powered down or follow hot-swap procedures recommended by your hardware vendor if inserting while active. The link should be recognised automatically by network devices supporting SFP+ AOC modules; verify link status and speed through your device management interface. Use appropriate cable routing to avoid sharp bends and ensure adequate airflow around connected equipment.

Recommendations

For reliable operation, avoid routing the cable through areas with excessive mechanical stress, maintain bend radii within manufacturer guidelines, and confirm compatibility with device firmware that supports active SFP+ optical assemblies. Regularly inspect connectors for contamination and clean with appropriate fibre-optic cleaning tools if necessary.