Cabo AOC CBO Palo Alto Networks SFP28-AOC-30M 30 m

AOC cable CBO Palo Alto Networks SFP28-AOC-30M 30 m is a direct attach active optical cable designed for use with Palo Alto Networks SFP28 ports and other compatible 25Gb/s SFP28 interfaces. The 30 meter length provides a single-cable optical link for short to medium reach connections between switches, routers and servers. This BlueOptics-manufactured AOC combines fiber-based signal transmission with an integrated transceiver module to reduce latency and simplify deployment in data center and network interconnect environments.

Advantages

The active optical design delivers lower insertion loss and reduced electromagnetic interference compared with copper alternatives while supporting 25Gb/s data rates. Integration of the transceiver into the cable eliminates the need for separate modules and patch cords, streamlining fiber management. The 30 m length offers flexible placement across racks or aisles without intermediate repeaters, and the plug-and-play SFP28 form factor ensures compatibility with common SFP28 ports for fast installation.

Suitable for

• Data center switch-to-switch uplinks at 25Gb/s
• Server-to-switch connections in high-density rack environments
• Aggregation links between routers and network appliances
• Short to medium reach fiber interconnects inside wiring closets and equipment rooms

Key specifications

• Interface: SFP28 active optical cable with integrated transceivers
• Supported data rate: 25 Gigabit per second
• Length: 30 meters
• Media type: multimode optical AOC
• Connector form factor: SFP28 plug compatible
• Typical use: short to medium reach optical interconnects

How to use

Plug each SFP28 connector into the corresponding SFP28 port on the devices to be connected, ensuring the ports are powered off or follow hot-swap guidance from device manufacturers if available. After physical installation, verify link status on both ends and configure interface parameters such as speed and auto-negotiation according to the network equipment’s requirements. No separate transceiver installation or fiber patching is required because the cable contains integrated optical modules.

Recommendations

Handle the cable by the connector housings and avoid sharp bends or tight cable ties; maintain the manufacturer’s minimum bend radius. Use appropriate ESD precautions when inserting or removing the connectors, and verify firmware or compatibility notes for Palo Alto Networks equipment to ensure full interoperability.