Cabo AOC CBO SFP-AOC-10G-20M – cabo ótico ativo 10 Gbit/s, 20 m

AOC cable CBO SFP-AOC-10G-20M — 10 Gbps active optical cable, 20 m is a factory-terminated active optical cable that provides 10 Gbps connectivity over a 20-metre link for network devices with compatible SFP+ ports. The cable integrates optical transceivers and a duplex fiber connection in a single assembly, removing the need for separate SFP+ transceivers and patch cords. It is intended for short- to medium-range links in data centers, server rooms and network racks where consistent 10 Gbps performance and reduced equipment footprint are required.

Advantages

The integrated design reduces installation complexity by combining transceivers and cable into one unit, which minimizes insertion points and potential signal loss. By using active optical technology, the cable delivers stable 10 Gbps throughput with lower latency compared to multi-component assemblies. Its 20 m length covers typical inter-rack and intra-rack distances while keeping electromagnetic immunity and thermal performance expected of single-mode/multimode optical links. The plug-and-play form factor supports rapid deployment and predictable signal characteristics for compatible SFP+ ports.

Suitable for

• Interconnecting switches, routers and servers with SFP+ ports in data centers
• Short- to medium-distance links between racks and equipment aisles
• Environments requiring reduced cabling complexity and predictable 10 Gbps links
• Upgrades from copper direct-attach to optical interconnects for lower latency

Key specifications

• Data rate: 10 Gbps full-duplex
• Length: 20 metres
• Connector type: SFP+ plug-integrated active optical assembly
• Optical type: active optical cable (AOC) with factory-terminated duplex optical channel
• Compatibility: designed for devices with SFP+ ports supporting 10 Gbps optics
• Typical use range: short- to medium-reach links within racks and between adjacent racks

How to use

Install the AOC cable by inserting each SFP+ plug end into the corresponding SFP+ ports on the connected devices until the retention latch engages. Ensure both endpoints support SFP+ optical attachments and that link settings on connected equipment are configured for 10 Gbps operation if necessary. Avoid excessive bending of the cable near the connector transitions; follow the manufacturer’s minimum bend radius recommendations for optical assemblies. Remove the protective dust caps from the plug ends before insertion and store them for future transport or replacement.

Recommendations

For reliable 10 Gbps operation, verify firmware and driver compatibility on network devices, route the cable to prevent sharp bends or compression, and handle connector ends by the housing to avoid contaminating optical interfaces. Use the 20 m active optical cable for inter-rack or in-rack connections where a direct, low-latency optical link is preferable to separate transceivers and patch cords.