Cabo DAC CBO QSFP28 100 Gbit/s 5 m — Direct Attach Copper (Modelo DAC-QSFP-100G-5M-BL)

CBO DAC-QSFP-100G-5M-BL is a 5 meter direct attach copper (DAC) cable with QSFP28 male connectors designed for short-range 100 Gbit/s links. The cable provides a low-latency, power-efficient physical connection between switches, routers and servers in data centers and network racks where fiber optics or active transceivers are unnecessary. Its fixed-length copper assembly simplifies rack cabling and supports high-bandwidth interconnects for top-of-rack, aggregation and leaf-spine network topologies.

Advantages

The direct attach copper design delivers low latency and reduced power consumption compared with optical transceivers and active modules at short distances. QSFP28 male connectors ensure compatibility with 100G-capable QSFP28 ports and provide a reliable mechanical mating. The 5 m length offers flexibility for common rack-to-rack and chassis-to-chassis connections while keeping signal integrity suitable for 100 Gbit/s operation. As a passive solution, the cable requires no additional power or SFP modules and simplifies inventory management.

Suitable for

• High-speed links between top-of-rack switches and aggregation switches
• Interconnecting routers and 100G-capable server NICs within the same rack or adjacent racks
• Leaf-spine and spine-leaf architectures in data center networks
• Short-range connections where optical transceivers are not required

Key specifications

• Connector type: QSFP28 male to QSFP28 male
• Data rate: 100 Gbit/s
• Length: 5 meters
• Cable medium: direct attach copper (passive copper assembly)
• Typical use: short-range, high-bandwidth interconnects in rack environments

How to use

Insert each QSFP28 connector into compatible 100G QSFP28 ports on network equipment until the latch engages. Ensure both ends are seated properly and that port LEDs or management interfaces indicate a valid link. Avoid sharp bends and maintain the cable bend radius recommended by equipment vendors to preserve signal integrity. For installation, route the cable along existing cable management paths to prevent strain and interference with airflow in racks.

Recommendations

Verify compatibility with the target devices' QSFP28 ports and port firmware; passive DAC compatibility can depend on hardware and firmware combinations. Use the 5 m length for short interconnects within or between adjacent racks, and keep the cable away from high-power electrical sources to minimize potential interference. For long-term reliability, inspect connectors for damage before insertion and replace the cable if the connector or conductors show wear.