Cabo SFP+ CBO AXC761-BL 1 m macho-macho 10 Gbit/s

The BlueOptics SFP+ Cable CBO AXC761-BL 1 m Male-to-Male is a direct-attach copper cable engineered for short-range 10 Gbit/s connections between compatible SFP+ ports. This 1-meter assembled cable provides a low-latency electrical link for high-density networking equipment such as switches, routers and servers. It is intended for compact data center topologies and server racks where reliable, high-throughput links are required without the need for optical transceivers.

Advantages

The SFP+ direct-attach design reduces overall cost and power consumption compared with separate optical transceivers and fiber. Its fixed 1 m length simplifies cable management in rack-mounted environments and minimizes signal attenuation and latency. The male-to-male SFP+ connectors offer plug-and-play compatibility with SFP+ ports that support direct-attach copper modules, enabling immediate link establishment at 10 Gbit/s when used with compatible equipment.

Suitable for

Key specifications

How to use

Insert each SFP+ connector into the corresponding SFP+ port on the two devices until the module latches. Ensure both devices support direct-attach copper SFP+ modules and have compatible link settings (speed and duplex). After physical installation, verify the link status in device management interfaces and configure network parameters as required. If the link does not establish, check port compatibility, firmware support and seating of the connectors.

Recommendations

Use this 1 m SFP+ direct-attach cable for short, point-to-point connections within the same rack or adjacent racks. Avoid sharp bends and excessive pulling force on the cable assembly, and keep the connectors free of dust when not installed. Confirm equipment compatibility with direct-attach copper SFP+ modules to ensure reliable 10 Gbit/s operation.