Módulo transceptor de rede CBO OSX010000-BO SFP+ 10 Gbit/s 1310 nm

The BlueOptics Network transceiver module CBO OSX010000-BO SFP+ 10 Gbit/s 1310 nm is an optical SFP+ plug-in designed for 10 Gbit/s fiber links using a 1310 nm wavelength. It fits into SFP+ ports on switches, routers and media converters to provide reliable uplink and interconnect capability for data center, aggregation and enterprise network environments. The transceiver supports short to medium reach fiber deployments and is intended for single-mode fiber applications where 1310 nm transmission is required.

Advantages

This SFP+ transceiver offers a standardized form factor for hot-pluggable installation, low power consumption and compatibility with devices that accept SFP+ optical modules. With a 10 Gbit/s data rate and 1310 nm wavelength, it enables high-bandwidth uplinks and inter-switch connections while maintaining optical signal integrity across single-mode fiber. The module simplifies upgrades and maintenance by allowing modular replacement without changing host hardware.

Suitable for

Key specifications

How to use

Install the transceiver into an empty SFP+ port on a compatible switch, router or media converter until it latches. Connect a single-mode duplex LC fiber patch cable to the module, observing correct TX/RX orientation. Ensure the connected device is configured for a 10 Gbit/s optical interface and that fiber routing and link parameters match single-mode 1310 nm operation. Monitor link status through the host device management interface and replace or reseat the module if the link does not establish.

Recommendations

Handle the optical connectors with care and keep dust caps on when the module is not in use. Verify transceiver compatibility with the host device documentation and confirm that cable type and distance are suitable for 1310 nm single-mode operation. Perform link tests after installation to confirm signal quality and expected throughput.