Módulo transceptor ótico CBO XFP-10GD-LR-BO, 10 Gbit/s, 1310 nm, XFP

The BlueOptics CBO XFP-10GD-LR-BO is an XFP optical transceiver module designed for 10 Gbit/s transmission over single-mode fiber at a 1310 nm wavelength. Intended for long-reach links, the module supports hot-swappable XFP connectivity and integrates with a range of switches, routers and optical systems commonly used in backbone, metro and data center environments. The module's form factor and operating wavelength make it suitable for reliable 10 Gbit/s optical links where distance and compatibility with XFP ports are required.

Advantages

This XFP transceiver provides stable 10 Gbit/s throughput with a 1310 nm optical interface optimized for long-reach single-mode fiber. The hot-swappable design minimizes downtime during maintenance or equipment replacement. The module is compatible with standard XFP cages and electrical interfaces, allowing easy integration into existing network hardware. Engineering focuses on signal integrity and thermal characteristics to ensure continuous operation in typical telecom and datacenter environments.

Suitable for

Key specifications

How to use

Install the module into an XFP-compatible slot on a switch, router or optical device while the host is powered according to the vendor's hot-swap guidelines. Connect single-mode fiber using appropriate LC/PC (or specified) connectors, ensuring correct polarity and clean end faces to prevent signal loss. Verify link status through the host device's management interface and monitor optical parameters such as transmit/receive power and error counters. Follow equipment-specific procedures for enabling or configuring the interface for 10 Gbit/s operation.

Recommendations

For reliable long-reach performance, use single-mode fiber with proper attenuation and connector cleanliness. Observe manufacturer and system vendor compatibility notes when mixing third-party transceivers with network equipment. Monitor optical power levels and temperature during installation and initial operation to confirm link stability.