Módulo transceptor SFP+ CBO E10G41BFSR-BO 10.000 Mbit/s 850 nm

CBO E10G41BFSR-BO is an SFP+ transceiver module designed for short-range 10 Gigabit Ethernet links. Operating at 850 nm wavelength and supporting a data rate of 10,000 Mbit/s, this hot-pluggable fiber optic module fits standard SFP+ ports to provide reliable high-speed connectivity between switches, servers and storage devices. The compact form factor and compatibility with SFP+ interfaces make it suitable for dense networking environments such as data center uplinks and aggregation layers.

Advantages

The module supports 10 Gb/s links over multimode fiber using an 850 nm VCSEL light source, offering low latency and stable throughput for short-distance connections. Its hot-pluggable design enables replacement or upgrades without powering down equipment. The SFP+ form factor ensures compatibility with a wide range of network switches, servers and optical equipment that accept standard SFP+ transceivers.

Suitable for

Key specifications

How to use

Insert the transceiver into an available SFP+ port on a supported switch, server NIC or storage device until it locks in place. Connect a multimode fiber patch cable with duplex LC connectors between paired modules. Verify link status through the host device interface and configure the network settings (speed, duplex, and relevant VLANs) as required. When removing the module, release the latch and gently pull the unit out; handle the optical interfaces with care and keep protective dust caps in place when not connected.

Recommendations

Use OM3/OM4 multimode fiber for optimal short-reach performance and maintain cleanliness of fiber connectors to prevent signal loss. Ensure the host equipment supports SFP+ 10 Gb/s transceivers and verify fiber type and connector compatibility before installation.