Transceptor CBO SFP-10G-BX-U módulo de fibra ótica 10G 1310 nm

The Transceiver CBO SFP-10G-BX-U 10G Fiber Optic Module 1310 nm is a single-mode SFP+ transceiver designed for 10 Gigabit Ethernet links over fiber. It fits SFP+ ports on compatible switches and routers and provides high-speed transmission at a wavelength of 1310 nm. The compact form factor and hot-pluggable design allow quick installation and replacement without powering down equipment, making it suitable for data centers, carrier networks and enterprise backbone links.

Advantages

This SFP+ module delivers reliable 10 Gbps performance with stable single-mode transmission and low power consumption. Its compact SFP+ form factor ensures wide compatibility with standard network equipment and supports long-distance links typical for metro and campus networks. The hot-pluggable design simplifies maintenance and upgrades, while factory-tested optical characteristics provide predictable signal quality and interoperability with SFP+ ports.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and routers
• Long-distance single-mode fiber connections in data centers and carrier networks
• Metro, campus and enterprise backbone links requiring 1310 nm wavelength
• Equipment upgrades where hot-pluggable SFP+ modules are required

Key specifications

• Data rate: 10 Gbps (SFP+ compatible)
• Optical wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Form factor: SFP+ (hot-pluggable)
• Typical reach: designed for long-distance single-mode links (refer to system requirements for exact distance)
• Connector type: LC duplex
• Power consumption: low-power SFP+ class (see device documentation for exact figures)

How to use

Insert the module into an available SFP+ port on a compatible switch or router until it clicks into place. Ensure the host device supports 10G SFP+ transceivers and the correct wavelength. Connect LC duplex single-mode fiber patch cords to the module’s connectors, observing correct transmit/receive orientation. After installation, verify link status and configure the interface on the network device according to operational policies. When removing the module, shut down the interface if recommended by the host device documentation, then pull the module straight out by the housing.

Recommendations

Use factory-tested single-mode fiber and high-quality LC patch cords to ensure optimal signal integrity. Check compatibility lists for the switch or router and confirm firmware supports SFP+ optics at 1310 nm. Avoid bending fiber beyond recommended radii and protect transceiver dust caps until final connection.