Transceptor CBO SFP-10G-LRM fibra ótica módulo 10G

The Transceiver CBO SFP-10G-LRM Fiber Optic 10G module is a hot-pluggable SFP+ transceiver designed for short-reach multimode fiber links. It enables 10 Gigabit Ethernet connectivity in a compact form factor compatible with standard SFP+ ports. The module is intended for deployment in data centers, enterprise network switches and routers, and telecom equipment where reliable short-distance 10G transmission over multimode fiber is required.

Advantages

This SFP+ transceiver supports 10G data rates over multimode fiber with a compact, hot-swappable design that simplifies installation and maintenance. Its compatibility with SFP+ cages allows flexible upgrades or replacements of existing ports without additional hardware changes. Built to meet conventional optical interface standards, the module provides predictable performance for short-reach links and reduces cabling complexity in dense networking environments.

Suitable for

• 10 Gigabit Ethernet connections over multimode fiber in data centers
• Aggregating or uplinking switches and routers in enterprise networks
• Short-reach links in telecom and campus network environments
• Replacing or upgrading SFP+ ports to enable 10G transmission

Key specifications

• Form factor: SFP+ hot-pluggable module
• Data rate: 10 Gigabit Ethernet
• Fiber type: Multimode fiber compatibility for short-reach links
• Optical interface: Duplex fiber connector
• Reach: Designed for short-reach multimode links (industry-standard LRM distance class)
• Power: Low-power SFP+ class transceiver

How to use

Install the transceiver into an available SFP+ port on a compatible switch, router or network interface device while the host is powered on or following the equipment vendor’s hot-swap guidance. Connect duplex multimode fiber patch cables to the module’s optical ports, ensuring correct transmit/receive orientation. Verify link status and configure the host device for 10 Gigabit Ethernet operation as required by the network setup. For safe handling, avoid touching the optical interfaces and keep protective dust caps on connectors when not in use.

Recommendations

Use industry-standard multimode patch cables and adhere to vendor guidance for fiber type and connector polish. Ensure proper fiber cleaning and connector inspection before insertion to maintain signal quality. Consider link budgeting and optical loss for patch panels and interconnects when planning short-reach 10G deployments.