Transceptor de rede SFP28 CBO BO27Q13610D-BO 25.000 Mbit/s 1310 nm

The BlueOptics SFP28 Network Transceiver CBO BO27Q13610D-BO is a compact, hot-pluggable optical module designed for single-lane 25 Gbit/s links. Operating at a wavelength of 1310 nm, this SFP28 transceiver supports high-speed data transmission for short- to medium-range fiber connections in data centers and telecom environments. It is intended for installation in SFP28-capable ports on switches, routers, servers and host bus adapters to provide reliable 25 Gbps connectivity.

Advantages

This SFP28 transceiver offers a standardized form factor with hot-pluggable convenience, enabling quick deployment and replacement without system downtime. The single-lane 25,000 Mbit/s capability provides full-bandwidth support for modern 25 GbE applications while the 1310 nm wavelength is suitable for multimode or single-mode fiber spans in short- to medium-range topologies. The module’s compact design minimizes space usage in dense rack environments and is compatible with a wide range of networking equipment that supports SFP28 optics.

Suitable for

Key specifications

How to use

Insert the SFP28 module into an appropriate SFP28 port on compatible networking equipment while the host device is powered on, taking care to align the module with the port guide rails. Connect the fiber patch cable with the correct connector type to the module’s optical interface, ensure proper polarity, and verify link status through the host device management interface. Follow the equipment vendor’s instructions for any required configuration or interface settings. When removing the module, disengage the fiber connector and pull the transceiver straight out using the module latch or ejector mechanism.

Recommendations

Use certified and well-maintained fiber cabling that matches the module’s wavelength and reach expectations. Verify compatibility with your switch or server vendor and confirm supported link modes and firmware requirements. Handle the optical interface with dust caps when not connected and avoid touching the ferrule to prevent contamination that can affect signal quality.