Transceptor ótico SFP+ CBO SFP-10G-ER-1310 10G 1310nm monomodo

SFP+ Transceiver CBO SFP-10G-ER-1310 is a 10 Gigabit single-mode optical module operating at 1310 nm. It is designed for long-reach, high-speed data links and fits standard SFP+ ports to provide 10G connectivity for network equipment. The module supports point-to-point connections over single-mode fiber and is intended for use in switches, routers and servers that require reliable 10G uplinks.

Advantages

The compact SFP+ form factor allows easy hot-plug installation in compatible ports and saves rack space compared with larger transceiver types. Operating at 1310 nm for single-mode fiber ensures effective performance over extended distances typical of ER-grade modules. The transceiver follows common electrical and optical interfaces for 10G single-mode links, enabling interoperability with standard networking hardware when used within supported specifications.

Suitable for

• 10G uplinks between switches and aggregation devices
• Long-reach point-to-point links over single-mode fiber
• 10G server network interfaces and high-bandwidth appliance connections
• Backbone or campus links requiring single-mode 1310 nm optics

Key specifications

• Data rate: 10 Gigabit per second
• Wavelength: 1310 nm (single-mode)
• Form factor: SFP+ (hot-pluggable)
• Link type: single-mode fiber, point-to-point/long-reach
• Typical application: 10G optical uplinks for switches, routers, servers

How to use

Install the transceiver into an available SFP+ port on network equipment until it seats and latches. Connect single-mode fiber with compatible connectors to the module's optical interface, observing correct transmit/receive orientation. Configure the host device for the desired 10G link settings and verify link status through device diagnostics or management interfaces. Follow the equipment vendor's guidelines for fiber handling and port configuration to ensure optimal performance.

Recommendations

Use clean single-mode fiber and appropriate end-face inspection tools before connection. Ensure optical power budget and link distance are within the module's supported range and check transceiver compatibility with the host device firmware if required. Avoid excessive bending of fiber and protect unused ports with dust caps when not connected.