Transceptor SFP+ CBO SFP-10G-BX-D 10G módulo de fibra ótica

CBO SFP-10G-BX-D is an SFP+ 10G fiber optic transceiver module from BlueOptics compatible with Dell equipment. Designed for 10 Gigabit Ethernet links over single-mode fiber, this compact hot-pluggable module supports high-speed data transmission between network switches, routers and servers. The transceiver is intended for point-to-point links and network upgrades where reliable, low-latency connectivity is required in data centers and enterprise environments.

Advantages

The module offers a standardized SFP+ form factor that enables easy hot-swap installation and reduces downtime during maintenance. Its compatibility with Dell network devices simplifies integration without the need for additional adapters. Optimized for single-mode fiber, the transceiver delivers stable 10 Gbps throughput and supports long-reach connections typical for data center interconnects. The compact design, low power consumption and support for standard 10G Ethernet make it suitable for dense port deployments.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and core network equipment
• Server-to-switch connections in data center racks
• Network upgrades from 1G to 10G using existing single-mode fiber
• Point-to-point long-reach links within campus or metro fiber networks

Key specifications

• Form factor: SFP+ (10 Gigabit capable)
• Data rate: 10 Gbps
• Fiber type: single-mode fiber (SMF)
• Interface: LC duplex connector
• Transmission range: suitable for long-reach single-mode links (device-specific reach depends on fiber and link budget)
• Hot-pluggable: yes
• Typical power consumption: low-profile SFP+ class

How to use

Install the transceiver into an available SFP+ port on a compatible Dell switch or other supported device while the host equipment is powered on or off as permitted by the device manual. Connect single-mode duplex LC fiber patch cords to the module with correct TX/RX orientation. Verify link status and speed in the host device management interface and adjust link settings if necessary. For best results ensure fiber connectors are clean and proper fiber type and cable specifications are used.

Recommendations

Before installation, consult the host device documentation to confirm firmware compatibility and supported modules. Use quality single-mode LC patch cords, maintain clean connector endfaces, and test links after installation to confirm expected 10 Gbps operation and signal levels.