Transceptor SFP+ CBO SFP-10G-BX-D fibra ótica 10G 1310nm

The BlueOptics SFP+ Transceiver CBO SFP-10G-BX-D Fiber Optic 10G 1310nm is a compact, hot‑pluggable optical module engineered for 10 Gigabit Ethernet links. It operates at a 1310 nm wavelength and supports bi‑directional single‑fiber transmission, enabling high‑speed connectivity between switches, routers and media converters. The module is suitable for deployments where space, power efficiency and straightforward upgradeability are priorities, such as data center uplinks and metropolitan or enterprise network segments.

Advantages

This SFP+ transceiver delivers 10 Gbit/s throughput over fiber while using a single fiber pair in bi‑directional (BX) mode, reducing fiber-count requirements. Its hot‑swappable form factor allows installation or replacement without powering down equipment, minimizing downtime. The module’s compact SFP+ profile saves port space in high‑density network equipment and is compatible with standard SFP+ interfaces, offering predictable performance for short to medium reach fiber links.

Suitable for

• Data center uplinks and switch-to-switch connections
• Metro Ethernet and ring networks requiring bi‑directional single‑fiber links
• Enterprise core and distribution layer aggregation
• Media converters and optical equipment requiring SFP+ 10G modules

Key specifications

• Form factor: SFP+ (10 Gigabit small form-factor pluggable)
• Data rate: 10 Gbit/s
• Wavelength (Tx/Rx): 1310 nm for transmission in bi‑directional mode
• Transmission mode: Single‑fiber bi‑directional (BX)
• Connector type: Optical fiber interface suitable for single‑fiber BX applications
• Hot‑pluggable: Yes
• Typical reach: designed for short to medium fiber distances in metro and enterprise networks

How to use

Insert the SFP+ transceiver into an SFP+ slot on a compatible switch, router or media converter until it clicks into place. Connect the single fiber using the appropriate fiber connector and ensure the remote end uses the complementary bi‑directional module or fiber configuration. Verify link status via the host device management interface and confirm correct wavelength pairing and link speed. To remove the module, disengage any retention mechanism and pull the transceiver straight out while the device is powered if hot‑swap is supported.

Recommendations

Use the transceiver in equipment that explicitly supports SFP+ BX modules and confirm firmware or vendor compatibility if necessary. Maintain clean fiber endfaces and follow standard ESD precautions during handling. For reliable operation, match transceiver types and verify link parameters in the network management system.