Transceptor SFP+ CBO SFP-10G-BX-U 10G 1310nm singlemode

CBO SFP-10G-BX-U 10G 1310nm single-mode is an SFP+ optical transceiver module that supports 10 Gigabit Ethernet over single-mode fiber at a 1310 nm wavelength. It is designed for insertion into standard SFP+ ports to provide a high-speed uplink or long-reach connection for network switches, routers and telecom devices. The module is suitable for data center interconnects, enterprise backbone links and upgrades of existing fiber infrastructures where a reliable 10G link is required.

Advantages

The transceiver delivers a 10G data rate on single-mode fiber using the 1310 nm window, offering a balance between reach and performance. Its SFP+ form factor ensures compatibility with many existing 10G ports and enables hot-pluggable installation without system downtime. The compact design and standardized interface make it straightforward to integrate into network equipment while maintaining consistent optical performance for long-distance links.

Suitable for

• Data center uplinks and inter-rack connections
• Enterprise backbone and campus network links
• Telecom equipment and metro aggregation
• Upgrading switch or router ports to 10 Gigabit Ethernet

Key specifications

• Form factor: SFP+ (hot-pluggable)
• Data rate: 10 Gbps
• Operating wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Typical application: long-reach 10G links
• Interface: LC duplex optical connector compatible

How to use

Install the SFP+ transceiver into a compatible SFP+ port on your switch, router or transceiver cage until it clicks into place. Connect single-mode fiber using an LC duplex connector, ensuring correct transmit/receive orientation. After connection, check link status and port settings on the host device and configure interface parameters such as speed and duplex if required by the equipment. Handle the module by its housing and avoid touching the optical interface; use protective dust caps when the transceiver is not connected.

Recommendations

Verify compatibility with the host device and confirm fiber type and link budget for the intended reach before deployment. Observe proper ESD handling and clean optical connectors to maintain signal integrity. For long-term reliability, monitor link status periodically and replace protective caps when the module is removed.