Transceptor SFP+ CBO SFP-10G-ER 10G Ethernet monomodo 40 km

CBO SFP-10G-ER is an SFP+ transceiver module designed for 10 Gigabit Ethernet transmission over single-mode fiber with a maximum reach of 40 km. The module follows the standard SFP+ form factor and supports hot-pluggable installation, making it suitable for high-speed uplinks, long-distance links and backbone connections in data centers, campus networks and carrier environments. It is compatible with common SFP+ ports on switches, routers and optical equipment and is intended for single-mode fiber links requiring extended reach.

Advantages

The transceiver provides 10G Ethernet performance with single-mode optics optimized for distances up to 40 km, enabling stable long-haul connections without intermediate regeneration. Its SFP+ form factor ensures broad compatibility with network devices while the hot-pluggable design allows maintenance or upgrades without powering down equipment. The module is designed for low power consumption and reliable operation in typical network environments, supporting straightforward integration into existing fiber infrastructures.

Suitable for

• 10 Gigabit uplinks between aggregation switches and core routers
• Long-distance links in data centers and between campus buildings
• Carrier and metro networks requiring single-mode fiber connections
• Optical equipment and transponder interfaces with SFP+ ports

Key specifications

• Data rate: 10 Gbit/s
• Optical interface: single-mode fiber (SMF)
• Maximum reach: up to 40 km
• Form factor: SFP+
• Wavelength: typical long-range transmission wavelength (LR/ER class optics)
• Connector type: LC duplex
• Hot-pluggable: yes
• Power consumption: low power SFP+ class (typical values depend on device)

How to use

Install the SFP+ transceiver into an available SFP+ port until it clicks into place, then connect the LC duplex single-mode fiber patch cable ensuring correct polarity. The device supports hot-plug insertion and removal; follow equipment vendor guidelines for port activation and monitoring. Configure the connected network interfaces on switches or routers according to your network topology and verify link status and optical parameters through the host device management interface.

Recommendations

Use high-quality single-mode fiber and LC duplex connectors to achieve the specified reach. Verify compatibility with the host device and, if needed, consult device documentation for supported optical modules and firmware requirements. Observe ESD precautions during handling and avoid bending the fiber beyond recommended radii to maintain link performance.