Transceptor SFP+ de fibra ótica CBO J9150DCM-BO 10.000 Mbit/s, alcance 300 m

CBO J9150DCM-BO is a fiber optic SFP+ transceiver that supports a 10,000 Mbit/s (10 Gb) data rate and is specified for a reach of up to 300 m. The compact pluggable module is designed for short-reach fiber links and fits standard SFP+ ports on switches, routers and servers. It provides a single-channel duplex optical interface for building high-speed connections in data center top-of-rack links, server uplinks and enterprise access aggregation where 10 Gb connectivity is required.

Advantages

The transceiver offers a standardized SFP+ form factor for hot-pluggable installation and easy replacement without powering down equipment. With a 10 Gb/s throughput and 300 m multimode reach, it enables low-latency links for short-distance fiber runs. The module is compatible with common SFP+ ports and is intended for systems requiring reliable optical connections with compact power and space footprint.

Suitable for

• Data center short-reach interconnects between switches and servers
• Server uplinks and top-of-rack connections
• Enterprise network aggregation and campus fiber links
• High-speed links in SAN and backup networks

Key specifications

• Nominal data rate: 10,000 Mbit/s (10 Gb/s)
• Maximum reach: up to 300 meters over multimode fiber
• Form factor: SFP+ pluggable transceiver
• Interface: duplex optical single-channel
• Target use: short-reach 10 Gb fiber links for switches, routers and servers

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on the networking device until it latches, then connect a duplex multimode fiber patch cable to the module’s optical ports, observing correct TX/RX orientation. Ensure connected devices are powered and configured to use the 10 Gb optical interface. Verify the link status via the device management interface and monitor optical signal levels where supported. For safe removal, disable the port if required by the host device and press the module release to extract the transceiver.

Recommendations

Use multimode fiber rated for short-reach 10 Gb/s to achieve the specified 300 m reach. Keep fiber connectors and module ports clean and protected with dust caps when unused. Match fiber type and connector standard on both ends to ensure link stability and check compatibility with the host device’s SFP+ port firmware if interoperability issues occur.