Transceptor SFP de fibra ótica CBO para Allied Telesis SFP-1G-ZX-160KM — 1 Gbit/s, 160 km

SFP-1G-ZX-160KM is a BlueOptics CBO fiber optic SFP transceiver compatible with Allied Telesis devices. It provides a 1 Gbps data rate and supports single-mode fiber links up to 160 km, making it suitable for long-distance uplinks between switches and routers or for metro network connections. The module uses a standard SFP form factor and implements optical interfaces intended for reliable, point-to-point optical connectivity over extended distances.

Advantages

The transceiver offers stable 1 Gbps throughput over single-mode fiber with an extended reach of up to 160 km, enabling long-haul connections without additional regeneration equipment. Its standard SFP form factor ensures broad compatibility with Allied Telesis hardware that accepts third-party modules. The device is designed for straightforward installation and low power consumption, helping to maintain operational efficiency in network racks and aggregation points.

Suitable for

• Long-distance uplinks between network switches and routers
• Metro area networks and inter-site connections
• Backup optical paths and disaster recovery links
• Point-to-point fiber links where extended reach is required

Key specifications

• Data rate: 1 Gbps (full duplex)
• Maximum link distance: up to 160 km over single-mode fiber
• Optical type: single-mode
• Form factor: SFP (small form-factor pluggable)
• Interface: LC duplex optical connector
• Operating temperature: industrial range typical for networking modules (verify device-specific limits before deployment)
• Power consumption: low-power SFP class (check system power budget for precise values)

How to use

Install the transceiver into an available SFP slot on a compatible Allied Telesis switch or router while the host device is powered according to the vendor's service instructions. Connect LC duplex single-mode fiber cabling using proper polarity and adhere to recommended fiber handling practices to avoid contaminating the optical interfaces. After installation, verify link status and speed via the host device interface and monitor signal quality to ensure expected performance over the planned distance.

Recommendations

Use certified single-mode fiber with proper attenuation levels for long-haul links and inspect/clean LC connectors before mating. Verify compatibility with your specific Allied Telesis model and firmware, and plan for suitable optical power margin and dispersion considerations for distances approaching 160 km.