Transceptor SFP de fibra ótica CBO SFP-1G-ZX — 1 Gbit/s, monomodo, até 80 km, LC

CBO SFP-1G-ZX is a fiber optic SFP transceiver module designed for single-mode optical links with a data rate of 1 Gbps and an operational reach of up to 80 km. The module uses an LC duplex connector and is intended for long-distance Ethernet and telecom connections, WAN uplinks and backbone links. It supports hot-plug installation and standard SFP form factor interoperability to simplify deployment in compatible network equipment.

Advantages

The module provides stable single-mode optical transmission over extended distances while maintaining a 1 Gbps throughput. Compact SFP form factor allows hot-swap replacement without powering down equipment. The LC connector and standardized electrical interface ensure compatibility with a wide range of switches, routers and media converters that accept SFP transceivers. The device is suitable for minimizing signal loss and maintaining link integrity on long-haul runs.

Suitable for

• Long-distance Ethernet links between buildings or sites
• WAN uplinks and metropolitan area network segments
• Backbone connections in service provider or enterprise networks
• Media converters and fiber aggregation modules requiring single-mode SFP

Key specifications

• Data rate: 1 Gbps
• Fiber type: single-mode
• Maximum link distance: up to 80 km (dependent on fiber and channel conditions)
• Connector type: LC duplex
• Form factor: SFP (hot-swappable)
• Application: Ethernet and telecom optical links, WAN/backbone

How to use

Insert the SFP module into an available SFP slot on a compatible switch, router or media converter until it clicks into place. Connect single-mode optical fiber with LC duplex connectors to the module, observing transmit/receive orientation. Configure the network device ports as needed for the 1 Gbps link and verify link status LEDs or management interface for an active connection. For removal, power down the port if required by the host device, then press the module latch and pull the SFP out by the housing.

Recommendations

Ensure fiber endfaces are clean and properly paired before installation to avoid signal degradation. Use single-mode fiber meeting relevant standards and match transceiver wavelength and fiber attenuation characteristics to achieve the specified range. Verify compatibility with host equipment's SFP port and follow ESD precautions when handling the module.