Cabo AOC CBO BlueOptics QFX-QSFP-AOC-2M 2 m QSFP cabo ótico ativo

AOC Cable CBO BlueOptics QFX-QSFP-AOC-2M is a 2-meter QSFP active optical cable engineered for high-speed direct-attach connections between QSFP ports. The factory-terminated design eliminates the need for separate transceivers, offering a compact, low-latency optical link for switches, servers and routers equipped with QSFP interfaces. This cable is intended for short-reach data center interconnects and campus backbone links where a plug-and-play solution reduces installation time and rack space.

Advantages

The active optical cable provides reduced power consumption compared with some discrete transceiver plus fiber assemblies and minimizes heat in dense rack environments. Its factory-terminated QSFP connectors ensure consistent signal performance and lower insertion loss compared with custom field-terminated assemblies. Plug-and-play installation and a fixed 2 m length simplify cable management and reduce the risk of connector mismatch.

Suitable for

• Short-reach links between top-of-rack and aggregation switches
• Server-to-switch high-bandwidth connections in data centers
• Interconnects in campus backbone or equipment rooms
• Environments requiring low-latency, high-density cabling

Key specifications

• Connector type: QSFP (quad small form-factor pluggable) terminated on both ends
• Length: 2 meters
• Cable type: Active optical cable (AOC) with integrated transceiver electronics
• Typical use: Short-reach multimode link for data center and campus environments
• Latency: Low-latency optical transmission suitable for high-throughput applications
• Compatibility: Designed for devices with QSFP interfaces supporting AOC links

How to use

Power down is not required in most modern systems; insert each QSFP connector into the corresponding QSFP port until the connector latches. Confirm port status and link lights on switches or servers to verify the connection. For removal, release the QSFP latch mechanism and extract the cable evenly to avoid stress on ports. Route the cable to avoid sharp bends and maintain the manufacturer’s minimum bend radius to preserve optical performance.

Recommendations

Install the cable in clean, dry environments and avoid exposing the optical ends to dust; when not in use, keep protective caps on connectors. Use the 2 m length to plan compact routing and minimize slack; avoid tight bends and excessive pulling force. Verify compatibility with your network equipment’s QSFP AOC policy and firmware to ensure proper operation.