Cabo DAC BlueLAN compatível com BlueOptics AX-F0110-3D1CU1M, SFP+ para SFP+, passivo, 10 Gbit/s, 1 m, preto (AX-F0110-3D1CU1M-BL)

The CBO DAC SFP+ cable 10G 30m model AX-F0110-3D1CU1M is a direct-attach twinax solution that provides a 10 Gbps connection over a 30-metre fixed link for compatible SFP+ ports. Engineered for short-reach interconnects, this pre-terminated cable removes the need for separate transceivers and supports low-latency data transmission between switches, servers and other network equipment. The cable is intended for rack-to-rack and adjacent-rack connections in data centre and enterprise environments where a reliable 30 m SFP+ twinax is required.

Advantages

This direct-attach twinax cable delivers a stable 10 Gbps link with lower latency compared to fibre-plus-transceiver combinations, simplifying installation through a pre-terminated SFP+ connector at each end. The fixed-length design reduces inventory complexity and ensures predictable signal characteristics over the 30-metre span. Built for short-reach topologies, it provides a cost-effective alternative to separate optics while maintaining compatibility with standard SFP+ ports used in switches and servers.

Suitable for

• Data centre uplinks between top-of-rack and aggregation switches
• Rack-to-rack connections within the same room or adjacent racks
• Direct server-to-switch links requiring 10 Gbps throughput
• Environments where a pre-terminated, low-latency direct attach solution is preferred

Key specifications

• Interface: SFP+ direct-attach connectors at both ends
• Data rate: 10 Gbps
• Length: 30 metres
• Cable type: Twinax (direct-attach)
• Suitable reach: Short-reach interconnects within racks or between adjacent racks
• Latency: Low-latency passive/active twinax characteristic (manufacturer dependent)

How to use

Insert each SFP+ connector into the corresponding SFP+ port on your networking devices until the connector latches. Ensure both devices support DAC SFP+ direct-attach cables and are configured for a 10 Gbps link. Verify link status in the device management interface and monitor for correct speed and error-free operation. Avoid sharp bends and excessive tension on the cable during installation to preserve signal integrity over the 30-metre span.

Recommendations

Use this 30 m SFP+ DAC twinax for short-distance, high-performance links where pre-terminated direct-attach cabling simplifies deployment. Confirm device compatibility with SFP+ DAC cables and follow rack-management best practices to maintain cable bend-radius and strain relief.