Cabo DAC QSFP28 BlueOptics QSFP28-DAC-3M-VA 3 m macho/macho

The BlueOptics QSFP28-DAC-3M-VA is a 3-meter passive direct attach copper (DAC) cable with QSFP28 connectors on both ends, engineered for high-speed 100GbE interconnects. Designed for short-reach links inside racks and across adjacent racks, the cable delivers low-latency, energy-efficient connectivity suited to data center top-of-rack and switch-to-server links. The QSFP28 form factor ensures compatibility with equipment that supports QSFP28 interfaces and passive copper twinax solutions.

Advantages

This passive QSFP28 DAC cable provides a cost-effective and power-efficient alternative to optical transceivers for short distances. The fixed 3 m length simplifies cable management while maintaining consistent signal integrity and low insertion loss. With industry-standard QSFP28 connectors, the cable supports reliable high-bandwidth transmission and reduces system power consumption compared with active or optical links.

Suitable for

• Short-reach 100GbE connections between switches and servers
• Top-of-rack and end-of-row data center cabling
• High-performance computing clusters requiring low latency
• Network equipment with QSFP28 ports supporting passive DACs

Key specifications

• Cable type: Passive direct attach copper (DAC)
• Connector type: QSFP28 male to QSFP28 male
• Length: 3 meters
• Supported data rate: 100 Gbps (QSFP28)
• Cable color: Blue
• Application: Short-reach rack and inter-rack connections

How to use

Install the QSFP28 connectors into compatible QSFP28 ports on source and destination devices, ensuring proper alignment until each connector locks into place. Use the cable for direct links within the same rack or between adjacent racks, avoiding tight bends and excessive stress on the cable assembly. Verify link status and data rate on connected devices and consult equipment documentation for any required port configuration or firmware settings.

Recommendations

For reliable operation, route the cable to prevent sharp bends and secure it to avoid tension. Use passive QSFP28 DACs like this 3 m cable where short-distance, high-throughput, low-power connections are required; for longer runs consider active copper or optical transceivers. Confirm compatibility with your switch or server vendor to ensure supported link speeds and to validate any vendor-specific requirements.