Cabo de coluna ShiverPeaks 06-241011, 4 mm², 25 m, CCA

ShiverPeaks 06-241011 speaker cable is a 25 m length audio cable with a 4 mm² conductor cross-section and CCA (copper-clad aluminum) construction. Designed for connecting amplifiers to loudspeakers in home and commercial audio systems, the cable balances conductivity and reduced weight while offering sufficient flexibility for routing along walls or inside conduits where installation rating permits. The transparent insulation reveals the conductor geometry and helps with polarity identification during installation.

Advantages

The CCA conductor provides a cost-effective alternative to pure copper while maintaining acceptable electrical performance for typical domestic and light commercial audio runs. The 4 mm² cross-section lowers resistance for moderate-length speaker connections and supports a range of speaker impedances. The 25 m spool length reduces the need for splicing on medium-distance installations and the flexible insulation simplifies handling and routing through channels and behind equipment.

Suitable for

• Wiring bookshelf or floorstanding speakers in home audio systems
• Connecting speakers in small public-address or background music installations
• Runs between amplifiers and speaker terminals where in-wall or surface routing is required and permitted
• Temporary or semi-permanent audio setups that require moderate flexibility and length

Key specifications

• Conductor type: copper-clad aluminum (CCA)
• Conductor cross-section: 4 mm²
• Length: 25 m
• Conductor strand construction: multi-strand for flexibility
• Insulation: transparent outer sheath for polarity visibility

How to use

Strip an appropriate length of insulation from each conductor end to expose the strands without nicking them. Observe amplifier and speaker polarity markings and maintain consistent polarity throughout the system. Terminate the cable using suitable connectors (banana plugs, spade lugs, or bare-wire clamps) rated for the conductor cross-section. Route the cable avoiding sharp bends, heat sources, and areas of mechanical stress. If used for in-wall installation, verify local building and fire safety regulations and use additional protective conduit or rated cable types where required.

Recommendations

For best performance, keep runs as short as practical and use the 4 mm² ShiverPeaks cable for lengths and speaker loads appropriate to its construction. When long runs or very low-impedance speakers are planned, consider using larger cross-section pure copper cable to minimize losses. Regularly inspect terminations for corrosion or looseness and replace or reterminate if needed.