Cabo de rede ACT DA4952 Cat6a U/FTP (STP) RJ-45 macho para RJ-45 macho 0,25 m preto

ACT DA4952 is a 0.25 m Cat6a U/FTP (shielded) slimline patch cable with an RJ45 straight connector on one end and a 90° angled up RJ45 connector on the other. The cable uses full-copper 32AWG conductors and 50 µin gold-plated RJ45 contacts. Its reduced outer diameter improves airflow in racks and cabinets and the LSZH jacket lowers the risk of toxic gas emission if the cable is damaged by fire or short circuit. The cable is designed for short 10 Gbps Ethernet patching where shielded performance and space-saving routing are needed.

Advantages

The slimline design (3.8 mm outer diameter) and smaller bend radius allow denser cable routing and better airflow compared with standard Cat6a patch cords. Shielded U/FTP construction and gold-plated contacts provide reliable signal integrity for high-speed links. The LSZH jacket reduces hazardous smoke and halogen release in case of fire, and the product is 100% tested and conforms to international standards.

Suitable for

When it may not be suitable

This 0.25 m patch cable is intended for short connections; it is not suitable for long-distance runs or horizontal cabling that requires longer lengths. Additionally, environments that do not require shielding or slimline cables may prefer standard-diameter unshielded patch cords for cost or compatibility reasons.

Key specifications

How to use

Connect the straight RJ45 end and the 90° angled up RJ45 end to the corresponding ports on switches, patch panels or other network devices. The angled connector helps route the cable upward from crowded ports or equipment rear panels without exceeding the cable's bend radius. Ensure shield grounding is implemented where required by your installation to maintain the cable's shielded performance.

What to consider before purchase

Recommendations

Use this slimline Cat6a U/FTP patch cable for short, high-speed 10 Gbps connections in racks and cabinets where space and airflow are constrained; verify shield grounding and choose the angled orientation that matches your equipment layout.