Cabo de rede Lanberg PCF6-10CU-0050-S RJ-45 Cat6 0,5 m cinzento

The Lanberg PCF6-10CU-0050-S RJ-45 Cat6 0.5 m Grey is a short, shielded Ethernet patch cable designed for reliable wired network links. Built to Cat6 specifications with F/UTP shielding, this 0.5 m cable reduces interference and supports stable data transmission between network devices. Equipped with RJ-45 connectors on both ends and finished in a neutral grey, it is suitable for tight cable runs behind equipment, patch panels, and desktop networking needs.

Advantages

F/UTP shielding around the twisted pairs provides protection against electromagnetic interference and crosstalk, improving signal integrity in electrically noisy environments. The Cat6 standard supports higher bandwidth and performance compared with older categories, enabling faster data transfer rates for local networks. The short 0.5 m length minimizes excess cable clutter and signal attenuation in short-link scenarios, while standardized RJ-45 plugs ensure compatibility with common network ports.

Suitable for

• Connecting a computer or switch to a nearby patch panel or wall socket
• Short links between network devices in racks or cabinets
• Desk setups where a compact, low-profile Ethernet cable is needed
• Environments with potential electromagnetic interference where shielding is beneficial

Key specifications

• Cable category: Cat6
• Shielding type: F/UTP (foil shield around all pairs)
• Length: 0.5 m
• Connectors: RJ-45 to RJ-45
• Color: Grey

How to use

Insert each RJ-45 connector into the corresponding Ethernet port until the latch clicks to secure the connection. Use the cable for short-distance links between devices such as switches, routers, patch panels, and networked computers. Route the cable to avoid sharp bends and mechanical strain on the connectors; ensure the shielding continuity by using compatible shielded ports or adapters if the installation requires end-to-end grounding.

Recommendations

For best performance, avoid running the cable parallel to mains power lines for extended distances and keep bending radii gentle. When using the F/UTP shield effectively, connect both ends to shielded ports or patch panels to maintain the shielding path. The 0.5 m length is optimal for short patch connections and reduces cable management complexity in dense setups.