Cabo de rede LOGON Cat6 UTP 10 m, RJ-45 — amarelo

LOGON Cat6 UTP networking cable, 10 m, with RJ-45 connectors on both ends, is designed for Gigabit Ethernet and structured cabling in home and office environments. The unshielded twisted pair construction (4 x 2 AWG 26/7) and 100 Ω characteristic impedance support reliable data transmission up to 250 MHz. The cable features molded boots with kink protection and strain relief for secure connector retention and easier handling. The yellow jacket improves visibility for cable identification and management in patch panels and network runs.

Advantages

The LOGON Cat6 UTP cable provides consistent performance for Gigabit networks thanks to Category 6 certification and a 250 MHz frequency rating. Its 26/7 stranded conductors balance flexibility and signal integrity, while the molded boots and strain relief reduce connector stress and extend service life. The bright yellow sheath simplifies routing and identification in multi-cable setups, making it straightforward to trace connections between switches, routers and endpoints.

Suitable for

• Connecting switches, routers and patch panels in office or home networks
• Workstation to wall outlet or network jack connections
• Patching between networking equipment in data cabinets and racks
• Temporary installations and cable runs where color-coded identification is needed

Key specifications

• Length: 10 m
• Cable category: Cat6 (Unshielded Twisted Pair)
• Conductor geometry: 4 x 2, AWG 26/7 stranded conductors
• Characteristic impedance: 100 Ω
• Frequency rating: up to 250 MHz
• Connectors: RJ-45 male on both ends with molded boot and strain relief
• Wiring: 1:1 straight-through termination
• Color: Yellow

How to use

Plug the RJ-45 connectors into the corresponding ports on network devices, switches or wall jacks, ensuring the molded boots are seated against the connector housing to maintain strain relief. Use the straight-through (1:1) wiring for standard device-to-switch or device-to-router connections. Avoid sharp bends near the connector boots and route the cable to prevent sharp kinks; secure with Velcro straps or cable ties without over-tightening. For tidy installations, label both ends to match your network documentation.

Recommendations

For optimal performance, keep cable runs under recommended maximum lengths for Ethernet links and avoid running parallel to high-power electrical cables to reduce interference. Use the yellow LOGON Cat6 UTP cable for visible identification in patch panels and bundle by function or segment. Inspect connector boots periodically for wear and replace cable if signal degradation or physical damage is observed.