Cabo de rede LOGON Cat6 UTP 10 m, RJ-45–RJ-45, vermelho

LOGON Cat6 UTP network cable, 10 m, with RJ-45 connectors on both ends, designed for Gigabit Ethernet over unshielded twisted-pair wiring. The flexible red jacket and standardized Cat6 construction provide a reliable connection for home and office LAN setups, patching between switches, routers and other network devices where a 10 m run is required. The cable supports up to 250 MHz and maintains a 100 Ohm characteristic impedance for consistent signal integrity.

Advantages

This Cat6 UTP cable features four twisted pairs with AWG 26/7 conductor specification and a molded boot with kink protection and strain relief to reduce connector stress during installation and use. The cable's red color improves visibility and cable management in racks or under desks. Category 6 testing and 3P Category 6 certification ensure compliance with performance expectations for Gigabit Ethernet applications.

Suitable for

• Wired Gigabit Ethernet connections in home or small office networks
• Patching between switches, patch panels and routers
• Connecting desktop PCs, NAS devices, IP cameras and network printers
• Temporary or permanent cable runs where a 10 m length is required

Key specifications

• Length: 10 m
• Cabling standard: Category 6 (Cat6) unshielded twisted pair (UTP)
• Conductor: 4 pairs, AWG 26/7
• Characteristic impedance: 100 Ohm
• Frequency rating: up to 250 MHz
• Connectors: RJ-45 male — both ends
• Jacket color: red
• Molded boot with strain relief and kink protection
• Pairing: 1:1 wiring

How to use

Connect one RJ-45 end to your network device such as a router, switch or network interface on a PC and the other RJ-45 end to the corresponding port on the remote device. Ensure connectors are fully inserted until they click to establish a secure connection. Route the cable to avoid sharp bends, heavy compression and sources of electromagnetic interference to preserve signal quality and mechanical integrity.

Recommendations

For best performance, avoid running the cable in parallel with power lines or near large motors; maintain gentle bend radii and secure the cable with appropriate clips or cable management to prevent strain. Use the red color to mark critical links or segregate network segments for easier identification during maintenance.