Cabo de rede LOGON SSTP Cat6a RJ-45 RJ-45 15 m marfim

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable, 15 m in ivory, is designed for high-speed wired Ethernet connections. It uses Cat6a construction with SSTP shielding and twisted pairs to support up to 10 Gbps transmission over copper, while maintaining flexibility for installation in home or office networks.

Advantages

Pairs with foil and full braid (SSTP) shielding reduce electromagnetic interference and improve signal stability. Four twisted pairs (4 x 2 x AWG 26/7) with 100 Ohm characteristic impedance ensure reliable high-frequency performance. Shielded RJ-45 male connectors with boots provide strain relief and kink protection, and a straight 1:1 EIA/TIA 568B wiring scheme ensures plug-and-play compatibility with standard network equipment.

Suitable for

• 10 Gbps Ethernet links within structured cabling systems
• Connecting switches, routers, patch panels and network devices
• Home offices, small business networks and data closet patching

Key specifications

• Length: 15 m
• Category: Cat6a (SSTP)
• Conductor: 4 x 2 x AWG 26/7 twisted pairs
• Impedance: 100 Ohm
• Connectors: 2 x shielded RJ-45 male
• Wiring: 1:1 EIA/TIA 568B
• Colour: Ivory

How to use

Connect one RJ-45 end to your network device (switch, router or NIC) and the other end to the corresponding port on the second device or patch panel. Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid sharp bends and place the booted ends near device ports to maintain strain relief. This cable follows the standard 568B pinout for immediate compatibility without additional configuration.

Recommendations

For optimal performance, avoid running the cable parallel to power lines for long distances and keep bend radii larger than the cable diameter. Use cable management (ties, trays) to prevent excessive strain and maintain the shielding connection at both ends for best EMI protection.