Cabo de rede LOGON SSTP Cat6a RJ-45 RJ-45 3 m amarelo

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable, 3 m, Yellow, provides a shielded connection for high-speed data transmission in structured networks. Constructed with four twisted pairs (4 x 2 x AWG 26/7) and paired foil and full braid shielding, this Cat6a cable supports 100 Ohm impedance and bandwidths up to 500 MHz. Both ends terminate in shielded RJ45 male connectors with boots offering kink protection and strain relief; wiring follows a 1:1 EIA/TIA 568B pinout for straightforward plug-and-play use.

Advantages

The combination of foil and full braid (SSTP) shielding reduces electromagnetic interference and crosstalk, improving signal integrity in congested or electrically noisy environments. AWG 26/7 stranded conductors balance flexibility and conductivity for reliable connections, while the shielded RJ45 connectors and protective boots enhance mechanical durability and prevent cable damage at the plug. The 3 m length and bright yellow jacket make routing and identification easier in rack or office setups.

Suitable for

• Connecting switches, routers and patch panels in office and server room environments
• High-speed Ethernet links up to Cat6a performance (up to 500 MHz)
• Environments requiring reduced interference, such as near power lines or dense cabling
• Temporary or permanent structured cabling where visible cable identification is helpful

Key specifications

• Standard: Cat6a, SSTP (foil + braid)
• Conductor: 4 x 2 x AWG 26/7, stranded twisted pairs
• Impedance: 100 Ohm
• Connectors: 2 × shielded RJ45 male
• Wiring: 1:1 EIA/TIA 568B
• Length: 3 m
• Bandwidth: up to 500 MHz
• Colour: Yellow

How to use

Plug one shielded RJ45 connector into your network device (switch, router, patch panel) and the other end into the corresponding port on the target device. Ensure the connectors are fully inserted until the latch engages. Route the cable to avoid sharp bends and maintain the boot’s kink protection; avoid running the cable parallel to high-voltage power lines to minimize interference. The 1:1 EIA/TIA 568B wiring enables direct device-to-device and patch panel connections without rewiring.

Recommendations

For optimal performance, use the LOGON SSTP Cat6a cable within its 3 m length rating and avoid placing it under mechanical stress. In high-interference areas, ensure proper grounding of connected equipment and use shielded patch panels or shielded switches to maintain shielding continuity.