Cabo de rede LOGON SSTP Cat6a RJ-45 RJ-45 5 m azul

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable, 5 m, blue, provides shielded twisted pair transmission for reliable high-speed data connections. It uses SSTP (foil and full braid shielding) with 4 pairs of AWG 26/7 twisted conductors and a characteristic impedance of 100 ohm, terminated 1:1 to the EIA/TIA 568B wiring standard. Both ends have shielded special RJ45 male connectors with boots that include kink protection and strain relief, offering a flexible yet durable patch cable for structured networks supporting up to Cat6a performance.

Advantages

SSTP shielding (foil plus full braid) reduces external electromagnetic interference and improves signal integrity over the cable length. AWG 26/7 twisted pairs support stable high-frequency transmission required by Cat6a, and the 1:1 EIA/TIA 568B termination ensures compatibility with standard network equipment. Molded boots with strain relief protect the connector junction and simplify installation in dense cable runs.

Suitable for

• Connecting switches, routers and patch panels in LANs
• High-bandwidth applications such as 10 Gigabit Ethernet over short to moderate distances
• Structured cabling where reduced EMI is required
• Office and data centre patching where a 5 m cable length is appropriate

Key specifications

• Cable type: SSTP (foil + braid), 4 x 2 x AWG 26/7 twisted pair
• Impedance: 100 Ohm
• Standard: Cat6a, up to 500 MHz
• Length: 5 m
• Connectors: 2 × shielded RJ-45 male (special)
• Termination: 1:1 — EIA/TIA 568B
• Colour: Blue

How to use

Plug one RJ-45 connector into the network port of your switch, router or patch panel and the other end into the target device. Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid sharp bends and excessive tension; use the molded boot and strain relief to protect the connector area. For best performance, keep the cable separated from strong power sources and large electrical equipment.

Recommendations

Use this Cat6a SSTP cable for short- to medium-length 10 Gigabit Ethernet runs and in environments where shielding against electromagnetic interference is important. Do not exceed recommended bend radius and avoid crushing forces to maintain signal quality.