Cabo de rede LOGON TCR55SS075O Cat5e SF/UTP (S-FTP) laranja, RJ-45—RJ-45, 7 m

LOGON TCR55SS075O Cat5e SF/UTP (S-FTP) Orange is a 7 m patch cable with RJ-45 connectors on both ends, designed for Ethernet links that require Cat5e performance and enhanced shielding. The cable uses SF/UTP (S-FTP) construction — an overall foil shield combined with individually shielded twisted pairs — to reduce electromagnetic interference and improve signal integrity in office or home LAN environments. The bright orange jacket makes the cable easy to identify in patch panels and cable runs.

Advantages

The SF/UTP (S-FTP) shielding provides improved protection against external EMI compared with unshielded cables, supporting stable data transmission in electrically noisy environments. Conductor geometry with 4 x 2 AWG 26/7 twisted pairs and 100 ohm characteristic impedance meets Cat5e requirements for reliable 100/1000 Mbps connections where Cat5e is specified. Molded boots with kink protection and strain relief reduce connector stress and extend cable life, while the 7 m length covers typical desk-to-wall or patch panel distances.

Suitable for

• LAN patching between switches, patch panels and wall outlets
• Office and home network links where improved EMI resistance is required
• Structured cabling segments that use Cat5e specification
• Color-coded cable management and quick identification in rack environments

Key specifications

• Category: Cat5e
• Shielding: SF/UTP (S-FTP) — overall foil plus individually shielded pairs
• Conductor: 4 x 2 AWG 26/7, stranded
• Characteristic impedance: 100 Ohm
• Length: 7 m
• Connectors: RJ-45 male to RJ-45 male, molded boots with strain relief
• Certification level: 3 P Cat5e certified
• Jacket color: Orange

How to use

Plug one RJ-45 connector into the network device or wall outlet and the other into the corresponding switch, router or patch panel port. Ensure connectors are fully inserted until the latch clicks to secure the connection. Avoid sharp bends and do not exceed the recommended bend radius; use the molded boot and strain relief to position the cable near the connector for reduced mechanical stress. For permanent installations route the cable through cable managers or trunking to prevent accidental disconnection and to maintain shielding continuity.

Recommendations

For best performance, use LOGON TCR55SS075O in environments where Cat5e-rated performance and EMI protection are sufficient. Keep cable runs within recommended length limits for Ethernet segments, avoid running parallel and close to high-voltage power lines, and terminate or connect shields properly in shielded installations to maintain the shielding effectiveness.