Cabo de rede LOGON UTP Cat.5e 5 m, azul, RJ-45–RJ-45

LOGON UTP Cat.5e network cable, 5 m, blue, with RJ-45 connectors on both ends is designed for standard Ethernet connections up to Cat5e performance. This unshielded twisted pair (UTP) patch cable supports balanced data transmission over four twisted pairs and is suitable for typical home and office network setups where reliable wired connectivity between devices is required. The cable jacket color provides easy visual identification in cabling runs.

Advantages

This Cat5e UTP cable provides stable wired connectivity for Ethernet devices and is compatible with switches, routers, computers and patch panels that accept RJ-45 terminations. The cable uses 26 AWG stranded conductors in twisted-pair configuration and maintains the 100 ohm characteristic impedance required for Cat5e performance. Molded boots with kink protection and strain relief reduce stress at the connector interface and the printed length indicator on the boot simplifies installation and maintenance.

Suitable for

• Connecting PCs, printers and network devices to a switch or router
• Patch panel to switch or patch panel to wall outlet connections
• Home and small office LAN wiring where Cat5e performance is sufficient
• Temporary or permanent desk- or rack-level network connections

Key specifications

• Category: Cat5e (unshielded twisted pair)
• Length: 5 m
• Connectors: RJ-45 male to RJ-45 male
• Conductor: 4 x 2, 26 AWG stranded (26/7)
• Characteristic impedance: 100 Ohm
• Cable jacket color: Blue
• Molded boot with kink protection and strain relief
• Wiring: 1:1 pinout (straight-through)

How to use

Plug one RJ-45 connector into the network port of your switch, router, patch panel or device and the other connector into the destination device. Ensure connectors are fully seated until the latch clicks. Route the cable to avoid sharp bends and keep it away from high-voltage power lines and sources of electromagnetic interference for best signal quality. For patch panel installations, use the printed length marker on the boot to confirm cable length during setup.

Recommendations

For reliable performance, avoid bending the cable sharply near the connectors and do not exceed recommended pull tensions. Use Cat5e-rated cable for connections up to 1000 Mbps under typical Ethernet conditions; consider upgrading to higher category cable for runs longer than standard office patch lengths or for future higher-speed requirements.