Cabo de rede ShiverPeaks Cat6 S/FTP 2,0 m

The ShiverPeaks Cat6 S/FTP 2.0m networking cable is a 2.0‑meter Ethernet lead built to meet Cat6 performance requirements. It uses a screen/foil (S/FTP) shielding structure to reduce electromagnetic interference and crosstalk, and gold‑plated RJ‑45 connectors to ensure reliable physical contact and corrosion resistance. The cable is intended for wired network connections where consistent high‑speed data transfer and signal integrity are needed.

Advantages

The S/FTP shielding combines an overall braided screen with individual pair foil shields to provide enhanced protection against external noise sources and internal pair interference. Gold‑plated RJ‑45 terminations improve contact reliability and reduce oxidation over time. At 2.0 meters length, the cable gives flexibility for desktop, wall outlet, or nearby network device connections without excessive slack.

Suitable for

• Connecting desktop computers, laptops, and network printers to a router or switch
• Home and small office wired networks requiring Cat6 performance
• High‑speed internet, video streaming, and large file transfers over Ethernet
• Connecting network devices in environments with potential electromagnetic interference

Key specifications

• Category: Cat6 performance class
• Shielding: S/FTP (overall braided screen + individually foil‑shielded pairs)
• Connector type: RJ‑45 with gold plating
• Length: 2.0 meters
• Suitable for speeds up to typical Cat6 limits (including Gigabit Ethernet)

How to use

Insert each RJ‑45 connector into the Ethernet ports of the devices you wish to connect, such as a router, switch, PC or modem. Ensure connectors click into place for secure contact. Route the cable to avoid sharp bends and sources of strong electromagnetic fields; leave gentle curves rather than tight folds. For wall or desk installations, secure the cable with appropriate clips or cable management to prevent strain on the connectors.

Recommendations

For best results, use this Cat6 S/FTP cable for connections within the specified 2.0 m distance to minimize latency and signal loss. Avoid running the cable alongside high‑voltage power lines and keep it away from large motors or fluorescent lighting to reduce interference. Inspect connector ends for dust or debris before installation and replace the cable if physical damage to the jacket or connectors is observed.