Cabo DisplayPort VALUE 11.99.5804

VALUE 11.99.5804 is a 5-meter DisplayPort to VGA (D-Sub) cable that enables connection of a graphics card or device with a DisplayPort output to a monitor or projector with a VGA input. The cable supports analog VGA displays and transmits video signals at resolutions up to 1920x1080 at 60 Hz, providing compatibility between modern DP sources and legacy VGA screens.

Advantages

The cable offers a reliable physical connection between DisplayPort sources and VGA displays without the need for additional adapters or converters. Its 5 m length provides flexibility for desktop setups and meeting rooms, while the VALUE construction ensures durability for repeated plugging and transport. It supports Full HD resolution (1920x1080@60Hz) for common office and multimedia uses.

Suitable for

• Connecting a PC or laptop with DisplayPort output to an older VGA monitor
• Connecting a DisplayPort-equipped graphics card to VGA projectors for presentations
• Extending desktop displays where only VGA input is available
• Temporary setups in classrooms, meeting rooms, or exhibition booths

Key specifications

• Brand: VALUE
• Model / MPN: 11.99.5804
• EAN: 7630049616325
• Type: DisplayPort (male) to VGA / D-Sub (male) cable
• Length: 5 m
• Maximum supported resolution: 1920 x 1080 @ 60 Hz

How to use

Connect the DisplayPort end to the DisplayPort output on your computer, laptop, or graphics card and the VGA (D-Sub) end to the VGA input of your monitor or projector. After connecting, power on both devices. The display settings on the source device can be adjusted in the operating system to set resolution, refresh rate, and display mode (duplicate, extend, or single display). No external power or additional drivers are required for basic video transmission.

Recommendations

For best results, set the source device to 1920x1080 @ 60 Hz if the VGA display supports Full HD. Avoid excessive cable bending and keep connectors free of dust. If no signal appears, verify that the DisplayPort source is set to output video over the DP connector and check cable seating on both ends.