Cabo ótico ativo BlueOptics AOC SFP+ 10G, 7 m, compatível com Netgear AXC7607 (BO353503J7M)

The AOC 10G 300m CBO compatible module for SFP+ Netgear AXC7607 (BlueOptics BO353503J7M) is an active optical cable designed for 10 Gigabit links on SFP+ ports. This factory-terminated fiber solution supports multimode connections up to 300 meters and is compatible with Netgear AXC7607 implementations. It offers a low-latency, high-bandwidth optical link for server, switch and storage interconnects where a pre-terminated cable reduces installation time and potential electromagnetic interference compared to copper alternatives.

Advantages

The module delivers 10 Gb/s data throughput over a single optical link and eliminates the need for separate transceivers and patch cords by integrating the active optical components into a single assembly. Its multimode design and 300 m reach permit flexible placement of equipment in data center and campus environments. The pre-terminated connector reduces field termination work and helps maintain consistent optical performance. As an AOC compatible with Netgear AXC7607, it can simplify inventory by matching form factor and electrical signalling expected by SFP+ ports.

Suitable for

• 10 Gigabit uplinks between switches and routers in data centers
• High-speed server-to-switch connections in rack environments
• Storage network links where low latency and high bandwidth are required
• Campus backbone segments over multimode fiber up to 300 m

Key specifications

• Interface: SFP+ compatible active optical cable
• Data rate: 10 Gigabits per second (10 Gb/s)
• Link type: Multimode fiber
• Maximum distance: 300 meters
• Connector: Factory-terminated SFP+ plug on both ends
• Signal: Optical transmission with integrated active components
• Compatibility: Designed to operate with SFP+ ports that accept AOC modules

How to use

Install the AOC by inserting each SFP+ plug into the corresponding SFP+ port on the networking devices until the module latches. Ensure both link partners support 10G SFP+ optical modules and that the ports are configured for the intended network settings (speed, duplex, and any required VLAN or trunking parameters). Verify link status via device LEDs or management interfaces and confirm established 10 Gb/s operation. To disconnect, release the retention latch and withdraw the connector straight out to avoid stressing the cable or port.

Recommendations

Store and route the cable to avoid sharp bends; maintain the manufacturer’s minimum bend radius. Use in multimode fiber environments with compatible transceiver expectations and verify firmware or compatibility lists if a specific vendor lock is a concern. Handle the optical connectors by the housing and keep dust caps on unused ends until installation to preserve optical performance.