Cabo SAS INTEL CYPCBLSLMIDPOUT SlimSAS para SlimSAS 0,11 m (Serial Attached SCSI)

Intel CYPCBLSLMIDPOUT is a Serial Attached SCSI (SAS) internal cable with SlimSAS connectors on both ends and a length of 0.11 m. It is intended for short, low-profile internal connections inside servers and storage enclosures, providing a direct SAS link between controllers, backplanes and drive enclosures. The compact SlimSAS design minimizes space usage and is suitable for dense 2U 2.5” drive systems where a short cable run is required.

Advantages

The cable offers a compact form factor and a short length that reduce cable clutter and improve airflow in rack-mounted systems. SlimSAS connectors on both ends ensure proper mating with compatible SAS ports and help maintain signal integrity for SAS links in tight spaces. The construction is designed for internal use and reliable connectivity between storage components in server environments.

Suitable for

• Short internal connections between SAS controllers and backplanes
• Connections inside 2U 2.5" systems with high drive density
• Linking drive enclosures to controllers where a low-profile cable is required

Key specifications

• Interface type: Serial Attached SCSI (SAS) with SlimSAS connectors
• Connector configuration: SlimSAS to SlimSAS, both ends
• Length: 0.11 m (approximately 11 cm)
• Application: internal server and storage enclosure connections
• Profile: low-profile, compact cable routing for dense drive bays

How to use

Install the cable by aligning the SlimSAS connectors with the corresponding SlimSAS ports on the controller, backplane or drive enclosure and seating each end until it is fully engaged. Use the cable for short runs only; avoid excessive bending or pulling to preserve connector and cable integrity. Route the cable to minimize obstruction to airflow and to prevent contact with hot components or sharp edges inside the chassis.

Recommendations

For best results, use this 0.11 m SlimSAS to SlimSAS cable for internal short-distance connections in 2U 2.5" high-density systems. Confirm compatibility with the server or storage backplane and ensure connectors are fully seated before powering the system. Avoid external use and exposure to mechanical stress to maintain signal performance.