Caixa adaptadora U.2 para SlimSAS NVMe, icy dock ToughArmor MB105VP-B, PCIe 4.0, suporta 2x unidades de 2,5 polegadas, 1x baía de 5,25 polegadas

The icy dock ToughArmor MB105VP-B is a PCIe 4.0-compatible adapter enclosure that converts U.2 NVMe connections to SlimSAS, enabling installation of two 2.5" drives plus a single 5.25" bay in systems that use SlimSAS interfaces. The unit is intended to integrate U.2 NVMe drives into chassis or backplanes that provide SlimSAS connections, delivering high-speed NVMe performance while preserving drive hot-swap and serviceability where supported by the host system.

Advantages

The ToughArmor MB105VP-B supports PCIe 4.0 throughput and maintains NVMe protocol compatibility while providing a compact enclosure for two 2.5" drives and one 5.25" bay. The design simplifies physical integration between U.2 NVMe drives and SlimSAS-based systems, reduces cable complexity, and supports hot-swap access where the chassis and controller allow. Constructed for rack or desktop installations, the enclosure offers a straightforward mechanical conversion without requiring drive-level modifications.

Suitable for

• Integrating U.2 NVMe drives into systems with SlimSAS backplanes or adapters
• High-speed storage expansion in servers, workstations, and compact systems
• Environments requiring quick drive replacement or hot-swap serviceability
• Upgrading systems that lack native U.2 connectors but provide SlimSAS

Key specifications

• Interface conversion: U.2 NVMe to SlimSAS (internal)
• PCIe generation support: PCIe 4.0 compatible
• Drive bays: supports two 2.5" drives plus one 5.25" bay
• Form factor: internal adapter enclosure for installation in standard drive bays
• Drive type supported: 2.5" NVMe U.2 SSDs (hot-swap support depends on system)

How to use

Install the ToughArmor MB105VP-B into an available 5.25" bay in the host chassis, secure the enclosure mechanically, and connect the SlimSAS cable from the system backplane or controller to the enclosure's SlimSAS port. Mount up to two 2.5" U.2 NVMe drives into the designated sleds or trays per the manufacturer's instructions, ensuring connectors are aligned before tightening any fastening screws. Power up the system and verify that the host recognizes the NVMe drives; configure RAID or storage settings as required by your operating system and controller. If the system and controller support hot-swap, drives can be removed and replaced while powered according to the host's hot-swap procedures.

Recommendations

Use high-quality SlimSAS cables rated for PCIe 4.0 signals and follow your chassis and controller guidance for hot-swap operations. Confirm firmware and driver compatibility of the host controller with NVMe U.2 devices and ensure adequate cooling in environments with sustained high I/O workloads to maintain performance and drive longevity.