CBO AOC SFP28 BlueOptics BO272703Q10M 10M cabo ótico ativo, SFP28, 10 metros

CBO AOC SFP28 BlueOptics BO272703Q10M is a 10-metre active optical cable in SFP28 form factor engineered for 25Gbps short-reach links. The integrated optical transceivers eliminate the need for separate modules, offering a compact, low-latency fibre connection between compatible SFP28 ports in switches, servers and storage equipment. The cable provides immunity to electromagnetic interference and is intended for data centre and rack-to-rack interconnects where reliable high-speed signalling and simple deployment are required.

Advantages

This BlueOptics active optical cable supports 25Gbps transmission over a 10 m distance while keeping power consumption and signal latency low. Its SFP28 form factor ensures direct plug-and-play compatibility with SFP28 ports, removing the need to install separate transceivers. The optical medium provides resistance to EMI and galvanic isolation, reducing crosstalk and electrical grounding concerns in dense rack environments. The single-cable solution simplifies cable management and helps maintain predictable link performance in short-reach applications.

Suitable for

• 25Gbps uplinks between switches and leaf-spine topologies
• Inter-rack and intra-rack connections in data centres
• Direct server-to-switch links for storage and compute nodes
• High-density network equipment with SFP28 ports

Key specifications

• Form factor: SFP28 active optical cable
• Nominal data rate: 25 Gbps per lane (single-lane 25Gbps link)
• Cable length: 10 metres
• Connector type: SFP28 plug-to-plug integrated optical transceivers
• Transmission medium: optical fibre (active AOC)
• Latency: low (typical for short-reach AOC links)
• Immunity to EMI and galvanic isolation provided by optical link

How to use

Insert each SFP28 connector into the corresponding SFP28 port on network devices until the module latches. Confirm link negotiation and speed in the device management interface or LEDs. No separate transceiver installation or fibre patching is required; the integrated optical modules and pre-terminated cable provide a single-step physical connection. Ensure both ends are fully seated and protected from excessive bending; consult device documentation for supported cable length and compatibility lists when configuring link speed and auto-negotiation settings.

Recommendations

Use the AOC for short-reach connections inside racks or between adjacent racks where 10 m is sufficient. Avoid tight bends or sharp kinks; maintain the manufacturer’s minimum bend radius for optical cables. Verify compatibility with the network equipment vendor’s supported optics list to prevent interoperability or firmware-related link issues.